What is a pool spider gasket?
Enter the pool spider gaskets. These gaskets are intended to seal up your pool’s multiport valve for efficient control over the direction of the pool water. They help in diverting the movement of the pool water and serve as the guardrail and lane markers that can guide pool water’s intended direction.
How long does it take to replace a spider gasket?
Replacing a spider gasket takes less than thirty minutes, the second time. Start by removing the handle. (right) The handle is held on with a steel pin, removable by tapping one end with a hammer and something solid of lesser diameter, like a thin wooden dowel or skinny Phillips head screwdriver.
What is the purpose of a spider gasket?
Its main purpose is to seal the seam between the pinwheel and the base of the multiport valve. What If My Spider Gasket Is Bad? When we select a desired path for our water, it surges through our pump, filter and back to the pool.
How to replace a spider gasket on a multiport valve?
Make sure that the gasket groove is free of water, grease, oils, debris and parts of the old gasket. Use NON-acetone finger nail polish remover to remove any gasket residue. Make sure the remover is NON-acetone or it will melt the plastic. Please note that not all multiport valve gaskets are glued in.
How do you blow out a spider gasket?
The quickest way to blow out a spider gasket is to move the multiport handle while the pump is running. If you doubt the veracity of this statement, try it now.
Replacing a spider gasket takes less than thirty minutes, the second time. Start by removing the handle. (right) The handle is held on with a steel pin, removable by tapping one end with a hammer and something solid of lesser diameter, like a thin wooden dowel or skinny Phillips head screwdriver.
How to change a spider gasket in a pool?
Changing a “spider gasket.” Had to change the spider gasket in a customer’s pool, and since it is so easy, I thought that I would provide a step-by-step. Here is the filter, a Pentair Tagelus… And the multiport valve… So the first step is to remove the 6 screws/nuts and bolts. The top housing of the valve shoud lift off.
How do you replace a multiport valve Spider gasket?
Just be generous with the grease and you’ll have no problem with this gasket. Fit the lid to the filter, lining the largest gap in the gasket up with largest gap in the valve body . Reset the teflon washer and grease it. Set the cap, lining up the screws; there’s only one way it will fit.
The quickest way to blow out a spider gasket is to move the multiport handle while the pump is running. If you doubt the veracity of this statement, try it now.
