What happens when the water pump is off in a spa?
1. Water temperature is unknown. 2. Spa is in Economy or Sleep mode. 1. After pump has been running for 2 minutes temperature will be displayed.breadcrumb breadcrumb 2. In Economy or Sleep mode, the pump may be off for hours outside a filter cycle.
When to turn on jets1 in a hot tub?
In Economy or Sleep mode, the pump may be off for hours outside a filter cycle. If you wish to see the current spa temperature, either switch to Standard mode or turn Jets1 on for at least two minutes.
How to reset spa message on calspas.com?
Press any button to reset or wait 15 minutes and spa will automatically reset. If message spa does not reset, call customer service. Insufficient water detected in heater. Spa is shut down. (Displays on third occurrence of dr message.) Follow directions for dr message and press any button to reset spa.
What to do if your hot tub pressure switch is defective?
To check to see if the pressure switch is defective or miscalibrated, please do the following: Power down the circuit board. Unplug the pressure switch cable from the circuit board, thus revealing two pins. Power up the system. As soon as the low/filter pump turns on, jump the two pressure switch pins on the board with alligator clips.
What should I do if my spa jets are not working?
Open this valve and there should be the sound of hissing air: keep open until water starts to come out, then close the valve. Force water directly into your spa’s jets with a garden hose, holding the hose directly but gently up against each jet for 20-30 seconds.
Is the FL1 button on my hot tub working?
Since the display is working and the icons show that the pumps are on when you push the jet button, the system is working, just no power feeding the components. FL1 should be a situation where the low speed pump just continually runs, but not heat. Start with a new fuse.
Why does my spa pump not pump water?
When a spa is emptied and refilled, air is frequently trapped in the plumbing. Since a spa’s equipment needs to have water in it to operate, your motors won’t pump when there’s air trapped in them. Fortunately, once this air is released from the system, everything should work properly.
Why does the GFCI breaker trip on my spa?
When a component is turning on and off due to circuit interruptions, the GFCI breaker may trip.Fixing loose connectors is pretty easy. Inside your spa pack, you may need to use a screwdriver to tighten the screws keeping wires in place.
