What happens if I refill my hot tub?
NEVER refill your hot tub with hot water—this will affect your sensors and send your electrical system on the fritz. 10) Turn the equipment back on once the spa is full (about 1 ½ inches above the highest jet). Turn on the power, heater, and jets to purge any lingering air from the plumbing.
What should I put in my hot tub before I drain it?
1) Before you drain the hot tub, take this time to purge your system. Adding a product like SeaKlear Spa Safety Flush will get any accumulated organic matter out of the plumbing and prevent you from having any persisting water chemistry issues. Add SeaKlear to water, about 8 oz. per 400 gallons of water (or 4 T per 1—gallons).
How long does it take to empty a hot tub?
Some hot tub units don’t have an exterior drain because they are prone to cracking and leaking water. In this case, use a standard hose to siphon out the water or run a sump pump to empty the hot tub. A quality sump pump typically only takes about 10-15 minutes to empty the tub. Don’t leave a sump pump to empty the hot tub without attending it.
Where is the drain plug on a hot tub?
If you have a hot tub with a gravity drain/plug system (could be either along the base of the unit or inside an outer panel—refer to your owner’s manual), remove the cap or plug and hook up a hose to the opening if you want to redirect the water elsewhere.
NEVER refill your hot tub with hot water—this will affect your sensors and send your electrical system on the fritz. 10) Turn the equipment back on once the spa is full (about 1 ½ inches above the highest jet). Turn on the power, heater, and jets to purge any lingering air from the plumbing.
How long does it take to drain a hot tub?
Depending on the size of your spa, it should take around an hour to drain using the hot tub’s drainage spigot, or ten minutes to drain with a submersible pump. To drain using the spigot: Turn the power to the spa off at the circuit breaker. You don’t want the pumps or jets to run while there isn’t any water in the spa.
How to get water out of a hot tub?
To drain using the spigot: 1 Turn the power to the spa off at the circuit breaker. You don’t want the pumps or jets to run while there isn’t any water in the spa. 2 Next, find your drainage spigot. 3 Attach the garden hose to the spigot, being careful not to cross-thread. 4 Open the ball valve on your spigot so the water can drain.
Is it safe to use a hot tub with a power source?
Not only is it dangerous to work with this amount of water while connected to a power source, it is also bad for your hot tub if the system powers on while its empty. Turn it off and completely disconnect anything electrical before you start to drain the tub.
