What happened to Spaform?
Now the business – which was in administration just before Christmas 2005 – has been sold on to Italian luxury bathroom business Teuco Guzzini. The spa maker is Spaform UK, based in Portsmouth, which has been manufacturing hot tubs in the UK since the early 1980s.
When to troubleshoot a hot tub blower cord?
If there is an internal wiring problem or other symptoms that have not been discovered. If there are no other issues you have an internal wiring or circuit board problem. If symptoms change, troubleshoot based on new indications. If power is present at blower receptacle, inspect blower cord for damage and replace if necessary.
What to do if your hot tub starts heating up?
First of all, open and close the spa door on the spa cabinet, and see if it starts heating. If the hot tub is gas-powered, you should check if the pilot light turned off and turn it back on. Another option is to replace the insulating cover since a damaged cover will affect the heating of the tub.
How to fix a flow problem in a hot tub?
How to fix a hot tub water flow problem 1 Check water level 2 Release any pump airlocks 3 Clean your hot tub filter 4 Check the pressure/flow switch 5 Check the pump is working
What should the voltage of a hot tub blower be?
Make sure before doing any troubleshooting that you completely disconnect any power to the hot tub. Most air blowers in hot tubs operate at 110 volts, but a few operate at 220 volts. You have to make sure the voltage you are providing to your blower matches the voltage it is meant to run on.
First of all, open and close the spa door on the spa cabinet, and see if it starts heating. If the hot tub is gas-powered, you should check if the pilot light turned off and turn it back on. Another option is to replace the insulating cover since a damaged cover will affect the heating of the tub.
What do I need to know about my spa heater?
The sensors in combination with specific software allow the spa to be controlled without the use of external pressure switches, flow switches, or temperature sensors. 1.Check sensor wires for cracks or damage that may indicate the presence of a rodent. 2. Inspect the connections of both sensors on the circuit board. The plugs must be clean. 3.
How old should my spa heater be before I need to replace it?
Heater failure is a very common problem, our simple procedure will help you identify heater failure, as a rule of thumb, if your spa is over 3-4 years old it is often more prudent to purchase the whole heater assembly and keep your old one for spares, as you get the sensors included.
What should I do if my spa water is overheating?
Under this mode, the pump will run the low speed every 30 minutes approximately to check the water’s temperature and to start heating if required. Please leave the Spa Cover off for a few hours and either reduce the set temperature or change the heating mode to Rest Mode to allow the pump to cool down.
