What does the Rheem error code 15 mean?
Rheem error code 15 means the heat exchanger is overheating. Check the vent terminals and exhaust venting and ensure nothing blocks the airflow near or around the unit. Check the heat exchanger and flush the unit if there are scale build-ups. The heat exchanger thermistor or the PCB may need to be replaced.
Where to find the Rheem error code on my water heater?
The error code is displayed on the LED display panel on the front of your continuous flow water heater. Please refer to the below listing to see what your error codes means, then call Rheem Service to book a service call on 13 10 31.
Why is my Rheem solar hot water not working?
My Rheem Solar Hot Water System is showing a fault code. Please see the Owner’s Guide for your Solar Hot Water System model. The temperature of the hot water from my Continuous Flow Water Heater fluctuates. The flow of hot water is not adequate to keep the water heater operating.
What kind of water heater does Rheem use?
George replaced his old storage water heater with a Rheem Gas Continuous Flow unit, so his hot water never runs out. Mei prepared for the needs of her growing family by installing a Rheem Gas Storage water heater. Doris replaced her old Rheem Electric Storage with the same model, and switched to an off-peak tariff, so she saves more on every bill.
Rheem error code 15 means the heat exchanger is overheating. Check the vent terminals and exhaust venting and ensure nothing blocks the airflow near or around the unit. Check the heat exchanger and flush the unit if there are scale build-ups. The heat exchanger thermistor or the PCB may need to be replaced.
What does the Rheem code 14 mean on a water heater?
More information can be found in your owner’s manual. Rheem error code 14 means the overheat film wrap has been activated, usually caused by a hot spot. The Rheem error code 14 can be caused by using the wrong type of gas, blocked or obstructed airflow, vent terminals and exhaust vents, and faulty or damaged heat exchanger.
What is the Rheem error code for low water flow?
Error Code P1: Low water flow rate. Rheem error code P1 means the water flow rates have fallen below 0.66 GPM for more than 5 seconds. If your Rheem displays an error code P1 the water flow rates are not sufficient for the main burner ignition. Ensure there is enough water flow, and the cold water inlet and aerator screens are clean.
Is there a problem with my Rheem hot water heater?
Also, this problem could be due to faulty tempering valve that is excessively cooling your hot water. Your local approved Plumber can test your system and replace the valve if necessary. To find your local Rheem Plumber, contact us or call Rheem on 1300 556 036. Do you have a solar water heater?
