What does the filter button do on a hot tub?
Your jets and your pump push the water through the hot tub filter to remove any particles in the water. The more water that can be pumped through the filtration system during a cycle the cleaner it will be. These cycles often run periodically through the day based on your bather load.
What does Flo error on my Sundance spa mean?
A FLO error is going to indicate something is wrong with your circulation system, so start with the simplest problem: your filter. Even if you think it should be fine, give it a try. Sometimes we can’t see the problem with our eyes.
What does Flo code on circa pump mean?
Nine times out of ten, a flo code means the pressure switch isn’t working, and ergo your circa pump wont work right, nor usually the heat. It’s a cheap part and won’t take a repair guy more the 20 minutes to fix.
What does a flashing Flo on a circ pump mean?
Typically Solid FLO msgs are related to a blockage, bad Flow switch and or connection, summer logic, bad PWA. Typically the circ pump would be off with a Solid FLO. A Flashing FLO msg could mean other things like a soiled filter, low water level, stuck weir door (not enough water supply to circ pump).
What to do if your GFCI is flashing Flo?
Make sure there is nothing in the filter area and turn your GFCI back on again. If the Flashing FLO message goes away within a minute then you have found where the problem lies with a dirty or soiled filter.
A FLO error is going to indicate something is wrong with your circulation system, so start with the simplest problem: your filter. Even if you think it should be fine, give it a try. Sometimes we can’t see the problem with our eyes.
How can I tell if my Sundance spa filter is defective?
The only way to test this is to make sure there is no loose debris in the spa, then pull the filter out and see if the flow error goes away, if it does, it is the filter. 2. Defective Circ Pump or Flow Switch: Need to check for Circ Pump operation.
What to do if the main pump is off in Sundance spa?
If debris is present, remove debris, install switch and test system. If condition still exist, replace switch.) if switch measures infinite (no continuity) with pump off, switch is OK, Turn on Main pump and measure across switch terminals for continuity. If continuity is measured, switch is OK.
Nine times out of ten, a flo code means the pressure switch isn’t working, and ergo your circa pump wont work right, nor usually the heat. It’s a cheap part and won’t take a repair guy more the 20 minutes to fix.
