What does standby mean on Hayward pool heater?
STANDBY: in this mode, the heater will not function to heat the water. 2. SPA: in this mode, the heater will automatically function to maintain the water temperature setting for SPA mode. To adjust the temperature while in SPA or POOL mode, use the UP and DOWN buttons.
What happens if the Hayward heat pump stops working?
Hayward heat pumps are equipped with safeguards that will stop operation to protect your unit in case of the following events: • Excessively high refrigerant pressure • Excessively high water temperature • Loss of refrigerant • Fan Motor Failure • Evaporator Freeze-up • Low Ambient Temperature •Refrigerant line blockage or overcharging
How to diagnose Hayward and summit Pool heat pumps?
The following heat pump diagnostic flow charts and accompanying wiring diagrams are to be used in diagnosing and repairing Hayward & Summit branded pool heat pump systems. They are not intended for use with any other manufacturers heat pumps. Summit Branded heat pumps are in Section 2 and have their own table of contents starting on page 32.
Where is the model number on a Hayward pool heat pump?
Model number is found on the data plate located on the bottom right of the electrical cover on Hayward Heat Pro units. On Summit style Heat Pumps the data plate is located on the left side of the base pan Leaking water
How can I get my pool heater back to automatic mode?
Typically, the maximum lock temperature is two or three degrees higher than the desired water temperature. Press the “Mode” button, and the heater will return to “Standby” mode. Press the “Mode” button again, and select the “Automatic” mode. Reattach the cover to the control panel.
The following heat pump diagnostic flow charts and accompanying wiring diagrams are to be used in diagnosing and repairing Hayward & Summit branded pool heat pump systems. They are not intended for use with any other manufacturers heat pumps. Summit Branded heat pumps are in Section 2 and have their own table of contents starting on page 32.
When to turn off Hayward pool heat pump?
This is normal and there is no reason to be concerned Water coming from bottom of unit Possible water leak. Turn the unit off for at least 2 hours, but leave the filter pump running continuously. If water dries up then it is only condensation.
What to do when your pool heat pump is not working?
Turn thermostat up until unit comes on. Be sure the 5 minute delay has passed. Make sure filter pump is on. (Note: the pool filter pump must be running before the heat pump will operate.) Call HAYWARD for service info. Adjust thermostat for higher heating temperatures. Refer to pages 4 to 7 to find your thermostat instructions.
Typically, the maximum lock temperature is two or three degrees higher than the desired water temperature. Press the “Mode” button, and the heater will return to “Standby” mode. Press the “Mode” button again, and select the “Automatic” mode. Reattach the cover to the control panel.
