What does SP-BR mean on gecko spa pack?

SP-BR means that the circuit breaker setting is too low and the spa is not getting enough power to run properly. SP-IN means that the input voltage is low. Check the circuit breaker and wiring to see if any fuses have blown. Reset fuse 1 or fuse 2 on the circuit breaker when SP-F1, F1 or F3 appear on the display.

Why is my gecko spa pack not working?

Sometimes the spa pack controls will display error codes or flashing lights. When this happens, the owner needs to do a bit of troubleshooting to fix the problem. Loosen the two screws that hold the cover onto the control pack. Lift the cover off to reveal the LED board.

What should water temp be in gecko spa?

The temperature inside the spa skirt is high when the display reads SP-OT. The overall water temperature is over 112 degrees when SP-OH is on the display. Always take care when working with electrical devices near water to avoid injury from electrical shock.

How to do the TSPA-MP metapacks service manual?

4 TSPA-MP Metapacks Service Manual Electrical Wiring Correct wiring of the electrical service box, GFCI box and pack terminal block is essential. 1• Carry out a visual inspection to check for signs of miswiring. Refer to supplied wiring diagrams. Call an electrician if necessary.

What causes GFCI tripping on a coast spa?

If breaker is wired properly, GFCI trippings may occur when total amount of current drawn by spa exceeds breaker rating. This is highly unlikely as each spa pack output is individually fused, and fuses will blow before GFCI trips.

Why is my coast spa power supply not working?

If all connections are made, but nothing seems to be working, you probably have a power supply problem. Carry out the following tests to identify and correct the problem: Note that for new installations, GFCI trippings due to miswiring are common.

What is the coast spas TSPA-MP service manual?

COAST SPAS TSPA-MP SERVICE MANUAL • Gecko Electronics Inc. • Visual step-by-step guide to easily identify & correct technical problems! Table of Contents Power & Ground Check Electrical Wiring 4 GFCI 5 Error Conditions