What does SL mean on my hot tub?
Sleep
SL: Sleep – Sleep mode will only allow the spa to heat within 20 degrees of the set temperature.
Is there a big list of Spa error codes?
Spa error codes can be somewhat cryptic, but when you have the BIG LIST of CODES, you can immediately define the two or three digit source of trouble. Problem is, there’s not much consistency among the error codes used by different spa pack manufacturers. Each company uses its own conventions for naming the various system faults.
How to get a hot tub to exit SL sleep mode?
On them you need to press the ‘TEMP’ button and then the ‘LIGHT’ button within three seconds of each other and this will change the modes from EC (economy mode), to SL (sleep mode) and finally to ST (standard mode) which is what you want. Read full interaction below » Ask Your Own Pool and Spa Question Share this conversation Resolved Question:
Where do I find the spa code on my heater?
With these spa sensor codes, the Temperature Sensor is open or shorted. The temp sensor and the high limit are usually located on the heater housing, with 1-2 small wires coming off and connecting to your controller. With the system powered off, you normally unscrew the sensors from the heater manifold, and unplug the wire from the panel.
What are the messages on the spa topside panel?
Read our FAQ! Here are the common spa topside panel messages that you will encounter with your spa panel. The spa topside panel messages include common diagnostic messages, operational messages, and various other messages such as reminders.
Spa error codes can be somewhat cryptic, but when you have the BIG LIST of CODES, you can immediately define the two or three digit source of trouble. Problem is, there’s not much consistency among the error codes used by different spa pack manufacturers. Each company uses its own conventions for naming the various system faults.
On them you need to press the ‘TEMP’ button and then the ‘LIGHT’ button within three seconds of each other and this will change the modes from EC (economy mode), to SL (sleep mode) and finally to ST (standard mode) which is what you want. Read full interaction below » Ask Your Own Pool and Spa Question Share this conversation Resolved Question:
What are the spa panel messages on Balboa?
Common Spa Panel Messages 1 Low Water Level. 2 Blocked Suction Fitting. 3 Blocked Skimmer. 4 Dirty Filter. 5 Too Many Closed Jets. 6 Closed Slice Valve. 7 Heat Related Pump Not Running. 8 Heat Related Pump Not Primed. 9 Contact your Dealer or Service Organization.
