What does se mean on hot tub panel?
in economy mode
The Big List of Spa and Hot Tub Error Codes
| CODE | ERROR CODE DESCRIPTION |
|---|---|
| SE | Spa in economy mode; system message, not an error |
| SEoP | Sensor open or disconnected; heater disabled but spa operational |
| SESH | Sensor short, nonfunctional; heater disabled but spa operational |
| SH | Short circuit on temperature sensor |
How to troubleshoot a spa control panel problem?
Reset the control panel if it only displays dashes and not error messages. Turn the power off for one hour and then turn it back on. If the control panel is displaying strange messages or have lights blinking at the same time, it could be a software issue with the circuit board. Check if there is corrosion or condensation.
What are the messages on the spa topside panel?
Read our FAQ! Here are the common spa topside panel messages that you will encounter with your spa panel. The spa topside panel messages include common diagnostic messages, operational messages, and various other messages such as reminders.
How does the hot tub control panel work?
The hot tub control panel is like a timer that keeps the spa’s temperature constant. It turns off the spa when you forget to and troubleshoots problems. Thus, it is very important to have a spa control system in good working condition. Many issues could face your spa, including electrical issues.
How to check spa panel messages on Balboa direct?
1. Turn OFF the Power to the System and Turn it back ON again to put System into Priming Mode. 2. After about 45 Seconds, Check for Error Messages on the Topside Panel Display. If there is No Error Message, Select “No Error Message” Below. If there is Now an Error Message, select Message Other than CrC or CHKSUM FAIL below.
What are the parts for a spa controller?
Topside Panel and Cords or Sold Separately. OEM part number 54478-03. This control system operates on 220V 60Hz 4-Wire (Line 1, SpaGuts brand CY Series Electronic Spa Controller Kit, Wifi Enabled, Model CY6200, is powered by Gecko Aeware, and offers an upgraded 2 year warranty instead of the standard 1 year warranty
Can a pneumatic spa controller be replaced with an electronic one?
Pneumatic spa controllers are simpler and less prone to problems. Internal parts within a Pneumatic spa controller can be individually removed and replaced. Electronic spa controllers are run by electronic circuit boards. The entire circuit board needs to be replaced if something fails.
What does it mean when spa goes into priming mode?
Pr = When spa is first actuated, it will go into Priming Mode. ILOC = Interlock failure – possible pump or ozone spike . (—) =Unknown water temperature. (Displays when first powered up after refill).
Is the hot tub control system the same as the spa?
Note: The control system brand name is usually different from the hot tub brand name. You can often determine the make of the control system by looking inside the spa’s equipment area. Disclaimer: Although we hope this information will be useful, error codes are subject to change without notice.
