What does protection mode mean on hot tub?

It will do this because the heating element is still hot, and when the power is lost, the hot element will continue to heat the water inside the heater. When power is restored, it reads that water temp as too hot inside the heater, and trips the high limit, requiring you to power down and reboot.

How do I reset my hot springs?

How do you reset the heater on a Hot Springs Spa?

Locate the spa’s high-limit reset. This is a red button found on many spa packs.
Press the high-limit reset button.
Turn on your spa and observe its operation.
Flip the breaker panel switch on or press the reset button on the GFCI outlet to restore power.

Why is my Hot Springs spa not heating?

Why is my spa not heating? Make sure: The water is at a level which covers all of the jets as this affects the water flow through the heater. The filter has been cleaned within the last four weeks by soaking it in BEAR STRIP FILTER CLEAN and that filter is not older than 18 months.

Why wont my hot springs heat?

Can a jetsetter be used in a hot spring spa?

The Jetsetter is a Hot Spring Spa that sits three very comfortably. You can find Replacement hot tub covers for all Hot Spring Spas models here. “Summer Logic” occurs when the actual water temp for the spa climbs to 2°F (1°C) above set temperatures and is more likely in extremely hot weather.

Is there an error code on my hot spring?

So, when you see an error code on your spa’s control panel, you might worry that you’ve lost your chance. But don’t fret! Hot Spring ® spa systems are reliable and will last a long time with regular maintenance, but issues do sometimes arise.

What should I do if my hot spring is not working?

1. Check to see if the water level is below the lowest pillow but above the jets. Add water if needed.2. Check for dirty or clogged filter cartridge .3. a) Remove filter cartridge in order to purge the air lock from the circulation pump intake.

What does it mean when a hot spring shuts down?

Stands for “Overheat”- and the tub shuts down because water temp is too hot. Temperature is not safe. The circ. pump will stop functioning to reduce frictional heating when water temp reaches 2°F (1°C) more than the set temperature.

What are the dangers of installing a hotspring tempo?

DANGER: RISK OF ELECTRICAL SHOCK • Install at least 5 feet (1.5 m) from all metal surfaces.

Where can I find the hot spring owner’s manual?

Please keep this manual available for reference. If you have any questions about any aspect of your spa’s set-up, operation or maintenance, contact your authorized Hot Spring dealership. They are trained professionals who are familiar with the product as well as new spa ownership concerns.