What does prime a pump mean?
What is pump priming? Priming simply means preparing or getting something ready for operation. For a centrifugal pump to work properly, you need to fill it up with water. The pump will resume operation once the air is removed.
How to fix the spa code of ” Dr “?
If the waterlevel is normal, make sure the pomps are (without air in them) After 15 minutes the spa will be reset. If the problem continues contact the dealer. Follow the same steps as under DR.
What happens in priming mode on a bullfrog spa?
During Priming Mode, the heater is not permitted to run. Keep in mind that the spa will turn on with Jets 1 during Priming Mode if it has a Circ Pump. When you exit the Priming Mode, the Circ Pump runs by itself. Means that the temperature of the water is unknown. The temperature will be displayed after the pump runs for 1 minute.
What to do if your master spa pump is not working?
While cleaning your filter make sure there is no debris in your hot tub that will get sucked down into your pump. Run a hot tub temporarily with filters out of the hot tub and see if the problem continues.
What to do if your Bullfrog spa pump is stuck?
SHUT DOWN THE POWER TO THE SPA. DO NOT GO IN THE WATER. Contact service organization or your dealer. Spa pump most likely is Stuck ON when the the spa was last powered. SHUT DOWN THE POWER TO THE SPA. DO NOT GO IN THE WATER. Contact service organization or your dealer.
While cleaning your filter make sure there is no debris in your hot tub that will get sucked down into your pump. Run a hot tub temporarily with filters out of the hot tub and see if the problem continues.
What to do if your hot tub pump is not primed?
There is usually no error message on the display because the motor, pump and other parts are, in fact, working fine, it’s just through laws of physics that the unpurged air is causing the jets not to work. You can prime your hot tub by purging the air yourself. Shut down the hot tub. Turn off the power at the wall.
If the waterlevel is normal, make sure the pomps are (without air in them) After 15 minutes the spa will be reset. If the problem continues contact the dealer. Follow the same steps as under DR.
What to do if your spa has more than one jet pump?
If your spa is equipped with a second jet pump, repeat the priming process for Pump 2 by pressing the “Jets 2” button once to turn on low speed and then a second time to turn Pump 2 on high. If your spa has a 3rd pump, press the “Jets 3” button to prime the third jet pump.
