What does PR mean on a Balboa hot tub?
Priming Mode
Spa is shut down. Pr = When spa is first actuated, it will go into Priming Mode. ILOC = Interlock failure – possible pump or ozone spike . (—) =Unknown water temperature. (Displays when first powered up after refill).
How to reset the sensors in a Balboa bp501 control system?
Step 3: Locate the heater’s sensor wires and trace them to where they plug into the circuit board (pictures below). Step 4: Disconnect the sensor wires from the circuit board.
How to check spa panel messages on Balboa direct?
1. Turn OFF the Power to the System and Turn it back ON again to put System into Priming Mode. 2. After about 45 Seconds, Check for Error Messages on the Topside Panel Display. If there is No Error Message, Select “No Error Message” Below. If there is Now an Error Message, select Message Other than CrC or CHKSUM FAIL below.
Where are the sensors on a Balboa hot tub?
Note: The below images refer to a Toronto Spa for the location of the control system. Placement varies from spa to spa, but in any case it will be located along the same side of the hot tub as the main control panel. Step 3: Locate the heater’s sensor wires and trace them to where they plug into the circuit board (pictures below).
Are there any end user serviceable parts for Balboa?
Balboa controls have absolutely no end user serviceable parts. Balboa Water Group does not authorize attempts by the spa owner/user to repair or service any Balboa products. Non-qualified users should never open or remove covers, as this will expose dangerous voltage points and other dangerous risks.
Step 3: Locate the heater’s sensor wires and trace them to where they plug into the circuit board (pictures below). Step 4: Disconnect the sensor wires from the circuit board.
What are the error codes on the Balboa spa?
Balboa Spa Side Error Codes pd Power supply, unit running on battery ba OH Sensors reading 112-118° F. OHH Overheat. Spa has shut down. One sensor OHS Overheat. Spa has shut down. One sensor
What is the installation manual for a Balboa spa?
End User Warning This Installation Manual is provided solely to aid qualified spa service technicians in installing spas with control systems manufactured by Balboa Water Group. Balboa controls have absolutely no end user serviceable parts.
Note: The below images refer to a Toronto Spa for the location of the control system. Placement varies from spa to spa, but in any case it will be located along the same side of the hot tub as the main control panel. Step 3: Locate the heater’s sensor wires and trace them to where they plug into the circuit board (pictures below).
