What does it mean when your water heater light blinks?
1 flash every 3 seconds means the pilot is lit and the gas valve is working normally. A solid red status light means the water heater is shutting down. The status light will flash more than once every 3 seconds if an error is detected.
Why is my Rheem water heater light flashing blue?
We installed a new Rheem 50-gal electric water heater last week. Today the Service Needed light started blinking – 5 times and then a pause. I see that … read more
What does it mean when your water heater flashes?
Start with the small print on the control panel. Usually, the most common messages are printed right on the control panel. If it’s not on there, check the manual or look up your model number online. For some models, a single flash is normal: It means everything is fine. Elsewhere, there isn’t much you can do about an electrical issue.
When is a blinking water heater light dangerous?
When Is a Blinking Water Heater Light Dangerous? Most times, the error message on your water heater isn’t a sign of danger. The blinking light tells you something’s up, but most models today shut off before anything becomes unsafe. But, if you are getting an error and notice any of the following, there’s cause for concern:
Why is there a blinking light on my water softener?
A blinking or flashing light on a water softener is simply an indication that something is not as it should be. It could be something as simple as you had a brief power outage and you need to reset the water softeners clock, often it is not anything to worry about, but you should find out what is going on.
Why does my Honeywell water heater not flash?
The Honeywell gas valve went into “High Temperature Shutdown” mode. When this happens, the gas valve closes, extinguishes the pilot light and your water heater stops heating water. You won’t see any flashes on the LED status light to help you determine the problem.
What should I do if my water heater status light is not flashing?
Look at the Status Light on the gas control valve. If the Status Light is flashing more than once every three seconds or not flashing at all, select the appropriate code below. If the Status Light is flashing once every three seconds, the pilot light is lit and the gas control valve is working properly.
How often does a Bradford gas water heater flash?
I keep holding the button and wait about 20-30 second … read more On a Bradford White gas hot water tank, model number MI40T6FBN, The pilot light lights but extinguishes when pilot button released. The LED shows one Flash and 3 second pause. Then it shows 2 quick fl … read more
What does Flash on Honeywell gas valve mean?
One flash, every three seconds, indicates your water heater is working properly. But, if you see no flash or more than one flash, the flashes, or error codes, indicate your water heater has a problem that needs fixing. On my particular Honeywell gas valve, model WV8840B1109, the error codes indicate the following:
