What does it mean when the water heater light is red?
A solid red status light means the water heater is shutting down. Turn the gas control valve OFF and wait 10 minutes before attempting to relight the pilot. Remember, 1 flash every 3 seconds means the pilot is lit and the gas valve is operating normally.
What does the blinking red light on my water heater mean?
Water Heater Red Light Blinking. by. Red LED on at thermostat. A blinking green STATUS light indicates that the microprocessor control, which is the “brain” of the unit, is operat-ing properly. may be used when the water heater is being serviced or replaced.
When does the water heater switch come on?
The light on my water heater switch only comes on when the switch is turned on, and the water heater is not running or has tripped a safety switch. So if the thermostat is not calling for heating (tank is hot) the light and burner will both be off.
When does the light go off on a hot water heater?
If the thermostat starts calling for heating, yet the burner is not on, the light will come on for the 2-3 seconds that it takes the igniter board to light the burner, then the light goes off.
How to turn on hot water heater indicator light?
Remove the water heater control panel (after making note of which wire goes where) and drill the appropriate sized hole in it. Then install the LED in the panel and route the “+” lead to the side of the switch that will be hot in the “on” position and the “-” lead to the ground side of the “Fail to Ignite” indicator light.
What does the red light on the hot water heater mean?
If the switch panel is as shown in the picture in the previous post, then the red light is a no ignition indicator as described by all. If there was an on off light it would most likely be incorporated into the toggle switch. Our previous RV had lighted switches.
The light on my water heater switch only comes on when the switch is turned on, and the water heater is not running or has tripped a safety switch. So if the thermostat is not calling for heating (tank is hot) the light and burner will both be off.
Why is my hot water heater not working?
9 Common Reasons Why No Hot Water (Tips to Fix) 1 Water Heater Has No Gas Supply Most times, the level of gas supply is a major problem. 2 No Pilot Light If you no longer see a flame, then it means your pilot light is off. 3 When There Is a Gas Leak The natural state of pure gas is colorless and produces no smells.
Why does my Propane water heater not light?
The green light comes on on the control panel, but nothing happens – the red light doesn’t come on either. You must have something different from what I have experience with. On most water heaters there is a red light in the on/off switch that turns on when you first turn it on and again each time that it attempts to light the propane.
