What does it mean when pool pump says no flow?
The most common reason for low or no flow is that the baskets are full of debris. By checking and emptying both the skimmer basket (by the pool) and the pump basket (inside the pump) this will free up the water flow, allowing the system to fully ‘prime’ and function at full capacity.
What to do if your Jandy pool sensor is not working?
Jandy recommends that you contact a pool professional for service if you encounter a Level 2 code. Heated sensor element not heating. (Generates 172 code) Contact a pool professional. Flow sensor temperature sensor failure. (Generates 172 code – flow sensor service)
What does a service code on a Jandy aquapure mean?
If you have a Jandy AquaPure 700 or 1400 chlorinator, there’s a chance you may have come across a service code (or error code) before. A service code is a three digit number that appears on the display panel of an AquaPure Control Box, letting you know if your AquaPure unit is experiencing any problems.
How to check salinity of Jandy aquapure pool?
Backwash filter if a DE filter is installed. Partially drain pool and dilute with fresh water until salinity returns to 3.0 to 3.5 gpl Unit wired to improper AC voltage. Contact a pool professional Verify proper flow/temperature/salinity sensor installation. Check salinity with Myron “L” meter calibrated for NaCl or test strips.
Why is there no flow in my Pool?
The pool is saltwater, inground about 60k liters, sand filter. Appreciate any help – especially if you have low cost solutions. Cheers. You could try and coat the wires with battery terminal grease. This should prevent the corrosion which seems to causing the problem.
When does no flow with Jandy aquapure stop?
You have to use a pen to push the little button in and it stops the pump, makes all of the lights by the buttons come on and go out then the pool starts up. It always resets the time in hand held to march 4, 2008 and noon or 1 pm.
Why does my Jandy pool have no flow?
An old problem has come back again. No Flow with the Jandy Aquapure Handheld and the LCD panel one green light on and no error codes which I used to get in the past. The sensor is only about a year and a half old. The Chlorine cell is about 4 years old.
Why does my hot tub have a Flo message?
The message can also be caused by soiled filters, plugged or bad Flow switches or a bad connection from the Flow switch to the PWA. In rare instances a bad PWA could cause a solid FLO message. If the pump checks out try and look at the filter, the circ line, the wiring to the Flow switch and the Flow switch.
Why is my hot tub running without a filter?
Try running the spa for a short period of time without the filter and jam your garden hose in the filter inlet. You could also have something plugging the circ line and or circ pump. You could also have a poor connection at the Flow switch and or a bad Flow switch.
