What does it mean when my hot tub says Flo?
water flow
FLO Error Message If your tub is displaying this message it simply means that there is an issue with water flow. The most common reasons for the FLO error message are dirty filters, a low water level, clogged circulation pumps or bad sensors. The first thing you should do is check your tub’s water level.
Do you have hot tub Flo error code on your hot tub?
If you have a Hot Tub FLO Error Code, this usually means there is an issue with water flow in your hot tub. If the flashing FLO error code is no longer there, your filters are clogged. They either need to be chemically cleaned over-night in filter cleaning solution or replaced if they are 1 year old or older.
Why does my hot tub have a flashing Flo message?
If the Flashing FLO message goes away within a minute then you have found where the problem lies with a dirty or soiled filter. It’s very important to remember that if you just finished fresh filling your spa then you could also have had an air lock that caused a Flashing FLO message. By removing the filter you just removed the air lock.
What to do if your hot tub has a bad flow?
If your spa is in Summer Logic, cool the water off by opening the cover and or adding some cold water to the spa. If neither of these are the case you could have a bad Flow Switch or a bad connection to the Flow Switch. If all else fails contact our Service support team to book a spa diagnostic and repair of your spa.
Why does my hot tub have no water movement?
If your Topside is displaying a Solid FLO message you will have no water movement in the spa. Inspect your Flow Switch for hair or debris wrapped around the paddle. Also check to see that your spa is not in Summer Logic (spa water reaches 2 DEGREES above the set temperature).
Why do I get a Flo error on my hot tub?
Another thing that you want to check is your skimmer and the filter area. When you look at the spa, you want to make sure that water is flowing in through the skimmer and that there’s no obstructions there. If you did have a filter in, for example, and you got something caught in the system, that can cause a FLO error.
Why does my hot tub have an error code?
If you have a Hot Tub FLO Error Code, this usually means there is an issue with water flow in your hot tub. Make sure there is no debris in the water that can get sucked into the pump If the flashing FLO error code is no longer there, your filters are clogged.
If your spa is in Summer Logic, cool the water off by opening the cover and or adding some cold water to the spa. If neither of these are the case you could have a bad Flow Switch or a bad connection to the Flow Switch. If all else fails contact our Service support team to book a spa diagnostic and repair of your spa.
Why do I get trouble shoot water Flo error?
The essential reason is the water flow through the spa control device, if the water isn’t always flowing at a charge to satisfy the pressure switch, it will result in one in every of the error codes indicated above. How to trouble shoot water flo error?
