What does it mean when it says no flow?
Blocked Baskets The most common reason for low or no flow is that the baskets are full of debris. By checking and emptying both the skimmer basket (by the pool) and the pump basket (inside the pump) this will free up the water flow, allowing the system to fully ‘prime’ and function at full capacity.
Why is the no flow light on on my Aqua rite?
“No Flow” LED illuminated The Aqua Rite has sensed a no flow condition and has stopped generating chlorine. unit and that the wire is not cut or damaged. Make sure you have at least 12″ of straight pipe before the flow switch. If there is adequate flow and the LED is still on, check that
What should I do if my no flow led is flashing?
If the No Flow LED is flashing, wait 60 seconds after starting your pump and filter. Ensure there are at least 12 inches of straight pipe before the flow switch. There should be NO elbow after the flow switch. Step 1: Wait 60 seconds after the pump starts.
How to reset the ” check system ” light?
1) There is a way to “reset” the “Check System” light (I think by holding in the Diagnostic button for 3 seconds?) This might fix it up… 4) Any chance wiring from flow sensor to control box got interrupted/disconnected? 5) If you don’t trust the sensor, get a salt test kit and compare them.
Why is the no flow light on in my Pool?
It is on its 2nd computer board and 2nd fuel cell. The fuel cell was replaced over the summer after it kept reading very low for the salt – and putting in a new one fixed it. Just came back from a trip and the pool is green. Apparently there is no chlorine. The “no flow” light comes on then goes off.
What does blinking red light on hot tub control panel mean?
Blinking Red Light. A blinking red light on the control panel may indicate it needs to be reset. For most models you will turn off the power to the spa for a minute or two and then turn it back on. Turn on the lower amp breaker first if you have a hot tub powered by 240 volts.
How to check if control unit is switched on?
Check the Control Unit is switched on. Switch off and unplug the unit before restarting. 3. Check the mains plug fuse (5 AMP) then check both Control Unit fuses (1 AMP) – fuses can be released using a screwdriver to push and turn. Do not try to open the Control Unit.
What to do when your status light does not blink?
If the status light does not start blinking after 90 seconds, release the gas control knob, turn the gas valve off, and wait 10 minutes before attempting to relight the pilot. On newly installed water heaters, it may take up to 2-3 lighting attempts before the pilot lights and the status light starts blinking.
What does the green light mean on the user manual?
User MarnuMa nerlreDs rlI RIEC ElreTHnAEnu 5 This symbol when illuminated (The green indicator light) is used to indicate that the equipment is on or ready for use.
