What does it mean when HTR is dry in a spa?
Heater starts again after 1 min. HTR MAY BE DRY – WAIT. Means there isn’t enough water to start it or a possibility of a dry heater – spa is shut down for 15 minutes. Check to determine conditions such as closed valves, suction flow restrictions, pump prime, low water level, trapped air and too many closed jets.
What to do if your Lay z spa pump is leaking?
Water Leakage. Error code for an issue with water leaking within the body of the pump. Check the couplings on the pump connections to ensure there is no water leaking from these. Also ensure the washers within these are flat. These can be checked using a screwdriver and simply unscrewing the coupling.
What does it mean when your Spa is shut down for 15 minutes?
Means there isn’t enough water to start it or a possibility of a dry heater – spa is shut down for 15 minutes. Check to determine conditions such as closed valves, suction flow restrictions, pump prime, low water level, trapped air and too many closed jets.
What should I do if my master spa pump wont work?
If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. This is the official YouTube channel for Master Spa Parts, the leading online retailer for Master Spa parts and filters!
When do I need to run a spa pump?
Sometimes the topside controls indicate that you need to run pumps to purge air after the tub is full and in use. This priming should take no more than two minutes, by which time water should flow (not surge) from all of the jets (assuming the jets are clean ).
What causes a spa pump to stop working?
Other causes of a non-working pump may be: 1 Pump cycle ended – press the button to turn the pump on. 2 Slice valves closed – open the slice valves. 3 No power – check pump connection in spa control box. 4 Blockage in line – clear obstructions in the filter assemblies.
Heater starts again after 1 min. HTR MAY BE DRY – WAIT. Means there isn’t enough water to start it or a possibility of a dry heater – spa is shut down for 15 minutes. Check to determine conditions such as closed valves, suction flow restrictions, pump prime, low water level, trapped air and too many closed jets.
What should water temp be to turn off spa?
Spa functioning is then disabled. Once water temperature is below 108°F (42.2°C), the System will then auto reset. Check for high ambient temperatures or extended pump operation.
