What does it mean when hot tub says heater may be dry?
A message such as “dr” or “dry” or “heater dry” is a warning that there’s no water in the heater tube, says Niagara Hot Tubs. Although safety sensors are supposed to detect a dry condition and shut off the heater, be sure to manually disconnect power to the pump and heater before troubleshooting the unit.
How to troubleshoot a problem with a Cal spa?
Troubleshooting 1 Message on the control panel. A message on the control panel may indicate a problem. 2 Problems starting up. Note: The priming procedure described here applies to Cal Spas built in 2013 and earlier. 3 Power and electrical problems. 4 Heat problems 5 Jet problems 6 Water pressure problems
When to call for service at a spa?
You may not be able to resolve every problem your spa may have. When that happens, you will be advised to call for service. If your spa is under warranty, you must have all service performed by a qualified spa service tech or you will void your warranty.
How can I tell if my Spa is overheating?
Press either the Temperature Up or Down button. While the temperature is flashing, press the Lights button. Keep pressing Lights until you get to the FLTR setting on your display. Press the Temperature Up or Down button until the display reads the current set duration (ex: “8:00” for EIGHT hours).
What does message on Cal spa control panel mean?
A message on the control panel may indicate a problem. Note: The message troubleshooting shown here applies to Cal Spa control panels built in 2013 and earlier. Beginning with the 2014 product line, Cal Spa control panels display different message codes. For a description of these message codes, see the owner’s manual.
Troubleshooting 1 Message on the control panel. A message on the control panel may indicate a problem. 2 Problems starting up. Note: The priming procedure described here applies to Cal Spas built in 2013 and earlier. 3 Power and electrical problems. 4 Heat problems 5 Jet problems 6 Water pressure problems
What happens if you raise the temperature on a Cal spas heater?
Raise the temperature on the control panel. If the HL or HFL message appears on the control panel, the pressure may be defective. This will shut down the heater. Call your dealer or Cal Spas customer service. A heating mode may not be selected.
You may not be able to resolve every problem your spa may have. When that happens, you will be advised to call for service. If your spa is under warranty, you must have all service performed by a qualified spa service tech or you will void your warranty.
Press either the Temperature Up or Down button. While the temperature is flashing, press the Lights button. Keep pressing Lights until you get to the FLTR setting on your display. Press the Temperature Up or Down button until the display reads the current set duration (ex: “8:00” for EIGHT hours).
