What does it mean chlorinator off no flow?
The most common reason for low or no flow is that the baskets are full of debris. By checking and emptying both the skimmer basket (by the pool) and the pump basket (inside the pump) this will free up the water flow, allowing the system to fully ‘prime’ and function at full capacity.
Why is my salt generator saying no flow?
The Hayward Aqua Rite has sensed a no flow condition and has stopped generating chlorine. Check that the flow switch is plugged into the connector on the bottom of the control unit and that the wire is not cut or damaged. Make sure you have at least 12″ of straight pipe before the flow switch.
How do I reset my chlorinator?
To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.
What does the chlorinator off no flow message mean?
Within minutes, the “Chlorinator Off No-Flow” message went away, and the only messages remain are as follows: “Chlorinator Off – Low Temperature”, and “Check System – Low Salt”. I have the following Temperature readings: Pool Temp: 57 Degrees F, Cell Temp Sensor: 58 Degrees F, Water Sensor: 57 Degrees F, Air Sensor: 57 Degrees F.
What are the messages on chorinator off no flow?
I also connected TurboCell connector to Main Board. Within minutes, the “Chlorinator Off No-Flow” message went away, and the only messages remain are as follows: “Chlorinator Off – Low Temperature”, and “Check System – Low Salt”.
When does the Hayward chlorine system turn off?
SWG’s won’t work below a certain temperature. As btolley mentioned, most swg cells will not produce chlorine at lower temperatures. I think the hayward turns off around 50F. I am not sure, will need to check tonight. Outdoor temperature has been about 60 to 65 degrees during day, and about 40 to 45 degrees at night. I line in Southern California.
How does the flow switch on a chorinator work?
Even a new cell will react to the cold water conditions and falsely indicate a low salt condition. The Flow switch will be the device that is connected to the power supply via a telephone looking cable.
Why does my chlorinator keep saying no flow?
I discovered that one of the leads in the chlorinator is covered by a white layer and needed cleaning with acid solution. The thing is this is happening quite frequently. After the last cleaning, the no flow indicator lit up again only after a few days. I used to have to clean the chlorinator only every few months.
What to do if your salt chlorinator cell is not working?
The first thing when it comes to dealing with a salt chlorinator cell that is not working is to identify the problem. Below are a few tell-tale signs of a dysfunctional unit. An LED signal indicating cell damage or overdue maintenance session. When the flow monitor indicates “NO FLOW” in spite of water moving through the cell.
What should I do if my Hayward Aqua rite stops producing chlorine?
The Hayward Aqua Rite has sensed a no flow condition and has stopped generating chlorine. Check that the flow switch is plugged into the connector on the bottom of the control unit and that the wire is not cut or damaged. Make sure you have at least 12″ of straight pipe before the flow switch.
Why is my Astral E25 salt chlorinator not working?
Got Astral E25 salt chlorinator installed 4 months ago. Working well. Few days ago, noted sign “no flow” on the screen. Had pool water checked recently, slightly low on the salt content so added the usual amount. Calcium level was also low so added. Checked pool cleaner (old zodiac genie), seems ok, no blockages in tubes.
