What does ILO mean on pool heater?
Ignition lockout
Raypak Heater Fault Code Guide
| Fault Code Display | Definition |
|---|---|
| HL2 | The high-limit has exceeded 135F |
| IGN | Ignition failure |
| ILO | Ignition lockout (Propane units only) |
| PRS | Low water pressure |
When to contact a technician about a pool heater ignition lockout?
Note if the digital display shows an ignition error code, such as “bD” or “HF” that indicate a problem with the gas-valve relay in the heater. Contact a technician if the controls do not automatically reset the relay in 2 minutes, as indicated when the indicator light and display begin flashing again.
What does Rheem stand for on a water heater?
Rheem (” Company ” or ” We “) respect your privacy and are committed to protecting it through our compliance with this policy.
Where can I Find my Rheem serial number?
Please click or tap here. Check out the innovative products featured in the show. Did You Know? You can enter the serial number u0003for your Rheem product to seeu0003 if it’s registered. More… More…
What should I do if my pool heater is locked out?
However, the general steps are: Put the system in standby using the control panel (typically accomplished by pressing and holding the Up & Down buttons) Check for an error code (if you see a code like bD or HF this could indicate a gas problem and your system will not reset until the problem is resolved)
Where to find the Rheem error code on my water heater?
The error code is displayed on the LED display panel on the front of your continuous flow water heater. Please refer to the below listing to see what your error codes means, then call Rheem Service to book a service call on 13 10 31.
Why is my Rheem solar hot water not working?
My Rheem Solar Hot Water System is showing a fault code. Please see the Owner’s Guide for your Solar Hot Water System model. The temperature of the hot water from my Continuous Flow Water Heater fluctuates. The flow of hot water is not adequate to keep the water heater operating.
How does the fault code work on a Raypak pool heater?
The majority of Raypak heaters will have a digital readout. The digital readout helps pool owners read error codes on the actual heater. The models with digital thermostats are programmed to display a variety of status and diagnostic messages, depending on the operating conditions. They are also equipped with onboard diagnostic controls.
Where can I find a Rheem approved plumber?
To find your local Rheem Approved Plumber, contact us or call Rheem Service on 1300 556 036. My Rheem Continuous Flow Water Heater is showing a fault code.
