What does if stand for on Hayward pool heater?

The Hayward heater LED display will show a diagnostic fault code of “IF” which stands for Ignition Failure. Undetected gas pressure problems if not investigated properly may result in unnecessary replacement and servicing of your Hayward Pool Heater.

How to troubleshoot a universal H series blower?

1. The control checks for open Blower Vacuum Switch 2. Blower starts pre-purge cycle as the igniter heats up (20 Sec). 3. The Control checks for a closed Blower Vacuum Switch. 4. At proper Igniter temp a 4 second trial begins. Gas valve opens and monitors flame sense. The blower will turn off for one second. The

How to test gas pressure on Universal H series heater?

Step 1: Step 2: Step 3: Press the Mode button to place the heater in Standby Mode. Hold the Mode and Down Arrow buttons simultaneously for 3 seconds for Bypass operation. “bo” will be displayed on the screen. Page 7 Gas Pressure Testing Measure the inlet Static Pressure (valve off) and Load Pressure (valve on / energized).

How to troubleshoot a Hayward Universal pool heater?

Troubleshooting chart for Hayward Universal H-Series electronic pool heaters with a digital display, models H150, H200, H250, H300, H350, H400 INPSECT WIRES FOR KINKS OR RODENT DAMAGE. INSPECT TERMINALS FOR BREAKAGE OR CORROSION REMOVE WIRES AND MEASURE OHMS WITH PUMP ON; IF CLOSED – SWITCH IS OK. IF OPEN, RECONNECT WIRES & PROCEED.

Is the Hayward pool heater made of gas?

The components of a Hayward pool heater are also very similar to gas heaters made by other manufacturers. To troubleshoot a gas-fired appliance, you have to think like a “combustioneer”.