What does IC mean on my hot tub?
When filling* your hot tub in cold conditions a warning message ‘IC’ or ‘ICE’ may appear. This is to inform you that the water temperature is below 7.2°C (45°F) and open to the risk of freezing. This commonly occurs when your water level is too low.
What does SL code mean on hot tub?
Sleep
SL: Sleep – Sleep mode will only allow the spa to heat within 20 degrees of the set temperature.
How do you change the mode on a hot tub?
The procedure for switching from one mode to another is different depending on the type of keypad installed on your hot tub. Keypads without a “Mode” button. Press “Temp”, then “Light” to switch to the next mode. Repeat the process until you reach the mode that you’re looking for.
What to do if your hot tub has an error code?
If however you have the fault then the first thing to do is shut the spa down, do not empty, remove the filter and make sure all the jets are open (as best you can). Then re-start the hot tub, if the error code goes away, the problem was either a dirty filter (clean or replace) or too many jets were closed off.
Why is my hot tub in economy heating mode?
If the Ecn or Ec Message is Alternating with the Water Temperature on the Display, the Spa is Operating in the Economy Heating Mode. If the Ecn or Ec Message is ON Solid (Not Flashing) on the Display, the Spa is Operating in the Economy Heating Mode, but there is No current water temperature because the Spa is between Filter Cycles.
What happens if your hot tub does not reset?
If the hot tub does not reset, shut off power to the spa and call your supplier for a service. “Overheat” – The spa has shut down. One of the sensors has detected that the spa water is at 43.5 degrees C. DO NOT ENTER THE WATER.
What does the code OH mean on a hot tub?
OH : Overheat. Spa temp over 108°. HLoH : Hi Limit Over Heat. Hi limit sensor is disconnected, shorted, or spa temp is above 112° F. SEoP : Sensor open or disconnected. Heater disabled but spa operational. SESH : Sensor short, nonfunctional. Heater disabled but spa operational.
If however you have the fault then the first thing to do is shut the spa down, do not empty, remove the filter and make sure all the jets are open (as best you can). Then re-start the hot tub, if the error code goes away, the problem was either a dirty filter (clean or replace) or too many jets were closed off.
When to use the spa and hot tub light?
The spa is at a temperature above 108° . Do not use spa when temperature is flashing or the OH message is displayed. HLoH = Hi Limit Over Heat. Hi limit sensor is disconnected or shorted or the spa temperature is above 112° F. SEoP = Sensor open or disconnected. Heater disabled but the spa is operational. SESH = Sensor short, nonfunctional.
If the Ecn or Ec Message is Alternating with the Water Temperature on the Display, the Spa is Operating in the Economy Heating Mode. If the Ecn or Ec Message is ON Solid (Not Flashing) on the Display, the Spa is Operating in the Economy Heating Mode, but there is No current water temperature because the Spa is between Filter Cycles.
What does ice stand for on Beachcomber Hot Tubs?
Shut the power down to the beachcomber hot tubs and call your store if the hot tub won’t reset. Stands for “Ice”- The system has detected a potential condition for freeze. No action is needed. The blower and pumps activate automatically in spite of the status of the hot tub unit. Means the hot tub unit has entered Standby mode.
