What does HP stand for on Dometic thermostat?
HP is your heat pump. That is the air conditioner – the unit will run in reverse and produce heat vs cold air. So for heating the trailer you can choose to use the HP or FURN.
How to troubleshoot a Dometic single zone thermostat?
Press the On/Off Mode button. (The LCD will be activated). Toggle through the modes until the On/Off green LED is on. Go out. Press the On/Off Mode button to go to the available modes. Press to advance to available mode. The green LED will indicate the mode selected either (Off, Fan, Cool, Furnace, Heat Pump or Heat Strip)
What to do if your Dometic heater is not working?
1. Clearing communications issues: your unit can get into a situation where the thermostat is not communicating with one or both upper boards. Turn the thermostat off, and turn power to the AC units off and on. Then turn the thermostat on and see if it works better. 2. Reset the thermostat to factory specs.
What happens if you lose 120 VAC in a Dometic thermostat?
Loss of 120 VAC power to all power module boards on the system. The system will shut down. Invalid zone configuration. The heat pump and heat strip DIP switches are both set to the ON position in one zone. Heat pump, heat strip, air conditioner, and dehumidify operation will be locked out in the affected zone.
What does the error code E1 mean on the Dometic thermostat?
Error Code: E1 Results from a loss of communication between the Single Zone LCD thermostat and its module board. LCD will cycle between E1 and the previous mode setting. The system eventually shuts down. E2 Open circuit or out of range Indoor Temperature Sensor.
Press the On/Off Mode button. (The LCD will be activated). Toggle through the modes until the On/Off green LED is on. Go out. Press the On/Off Mode button to go to the available modes. Press to advance to available mode. The green LED will indicate the mode selected either (Off, Fan, Cool, Furnace, Heat Pump or Heat Strip)
1. Clearing communications issues: your unit can get into a situation where the thermostat is not communicating with one or both upper boards. Turn the thermostat off, and turn power to the AC units off and on. Then turn the thermostat on and see if it works better. 2. Reset the thermostat to factory specs.
What is the zone for Coleman RV comfort?
I have a Coleman RV Comfort.ZC thermostat with two furnaces and two AC units attatched. ZOne 1 and ZOne 2. Thermostat reads ZOne 2 (working) and ZOne 4?
What’s the problem with my rvcomfort ZC thermostat?
My Thermostat (RVComfort.zc) controls all thee. My problem is: I am locked on Zone 1. I cannot switch to zone 2 or 3. I can set the Temp. but zone on … read more I have a 2003 Fleetwood Providence. The RVComfort.ZC thermostat has for several years about once a week gone to 00 in the temperature part of the LCD.
