What does HL mean on my Arctic spa?
shut the heater down
HL. When “HL” error message displays, it means the system shut the heater down because temps at the heater reached 119ºF (48ºC). When “HL” error message is flashing, it means the system shut down because the water temps in the spa reached 112ºF (44ºC). In this condition, only Smart Winter Mode will remain active.
What happens if FLC error is displayed on Topside?
In the event of an FLC error the heater is also prevented from running and “FLC” is displayed on the topside. If the heater is allowed to run without water flowing through the heater, the heater will over heat and risk damage to the spa and fire.
How to diagnose a Flo message on a hot tub?
Answer: When diagnosing a FLO message it is important to consider that there are 3 different types of FLO messages that your Spa’s logic is capable of displaying (a Solid FLO message, a Flashing FLO message and a Solid FLO2 message). First determine which message you are seeing.
What to do if there is no error message on the topside panel?
Turn OFF the Power to the System and Turn it back ON again to put System into Priming Mode. 2. Press any “Cool”, “Warm”, or “Temp” Button to Exit Priming Mode. 3. After about 45 Seconds, Check for Error Messages on the Topside Panel Display. If there is No Error Message, Select “No Error Message” Below.
What does a flashing Flo on a circ pump mean?
Typically Solid FLO msgs are related to a blockage, bad Flow switch and or connection, summer logic, bad PWA. Typically the circ pump would be off with a Solid FLO. A Flashing FLO msg could mean other things like a soiled filter, low water level, stuck weir door (not enough water supply to circ pump).
In the event of an FLC error the heater is also prevented from running and “FLC” is displayed on the topside. If the heater is allowed to run without water flowing through the heater, the heater will over heat and risk damage to the spa and fire.
When do I get a HL or HFL message?
Displays on the fifth occurrence of the HL or HFL message within 24 hours. Follow action required for HL or HFL message. Heating capacity of the spa will not reset automatically. Press any button to reset. Overheat protection. The spa has shut down. One of the sensors has detected that the spa water is 110°F.
What does Flo mean on a hot water heater?
If it is hot you have a flow issue, or if it stays hot after the pump is shut off either the pressure switch has stuck close (see FLO error codes above) or the relays on the board have stuck shut sending continuous power to the heater.
Answer: When diagnosing a FLO message it is important to consider that there are 3 different types of FLO messages that your Spa’s logic is capable of displaying (a Solid FLO message, a Flashing FLO message and a Solid FLO2 message). First determine which message you are seeing.
