What does Flo mean on gecko hot tub?
an issue with water flow
If you have a Hot Tub FLO Error Code, this usually means there is an issue with water flow in your hot tub.
What does e2 mean on hot tub?
E02 ERROR CODE REASON WATER LEVEL IS NOT CORRECT. The water flow sensors will not detect the water properly if the water is below the minimum line. on the spa liner.
What does SC mean on hot tub?
System learning failure
1) Hot Tub Error Codes (Alphabetical)
| * * * (3 flashing dots under temp display) | Flow/Pressure switch either Open or Closed Circuit |
|---|---|
| SC-ER | System learning failure |
| SE | Spa operating in Standard-in-Economy Mode |
| SEoP | Sensor open or disconnected. Heater disabled but spa operational |
What causes Flo error message on Sundance Altamar spa?
I have a Sundance Altamar spa, and I’ve occasionally had that FLO error message too in the past. If I recall it might have been caused by air in the lines (not filling tub properly?) or possibly from obstruction. I had one of the small cotton intake covers get sucked into pipes before.
Why does my Sundance spa not heat up?
It sits 3. I have noticed that that I have a constant FLO error, and the water will NOT heat unless the jets are running. I also believe that my circulation pump is causing these issues. It buzzes and is warm to the touch, but I can’t feel the water moving at all. I just don’t think it is working properly.
What does Flo code mean on Sundance heat pump?
I found it easily at the Sundance site online and keep a copy on my computer for reference. Nine times out of ten, a flo code means the pressure switch isn’t working, and ergo your circa pump wont work right, nor usually the heat. It’s a cheap part and won’t take a repair guy more the 20 minutes to fix.
What should I do if I get a Flo error on my spa?
Some of them may require a skilled technician to come out and work on your spa for you. 1. The first thing to do if you have a FLO error is to remove your filter and clean it. A FLO error is going to indicate something is wrong with your circulation system, so start with the simplest problem: your filter.
What does Flo error on my Sundance spa mean?
A FLO error is going to indicate something is wrong with your circulation system, so start with the simplest problem: your filter. Even if you think it should be fine, give it a try. Sometimes we can’t see the problem with our eyes.
How can I tell if my Sundance spa filter is defective?
The only way to test this is to make sure there is no loose debris in the spa, then pull the filter out and see if the flow error goes away, if it does, it is the filter. 2. Defective Circ Pump or Flow Switch: Need to check for Circ Pump operation.
It sits 3. I have noticed that that I have a constant FLO error, and the water will NOT heat unless the jets are running. I also believe that my circulation pump is causing these issues. It buzzes and is warm to the touch, but I can’t feel the water moving at all. I just don’t think it is working properly.
What to do if the main pump is off in Sundance spa?
If debris is present, remove debris, install switch and test system. If condition still exist, replace switch.) if switch measures infinite (no continuity) with pump off, switch is OK, Turn on Main pump and measure across switch terminals for continuity. If continuity is measured, switch is OK.
