What does Flo mean on a Jacuzzi hot tub?
issue with water flow
FLO Error Message If your tub is displaying this message it simply means that there is an issue with water flow. The most common reasons for the FLO error message are dirty filters, a low water level, clogged circulation pumps or bad sensors. The first thing you should do is check your tub’s water level.
What does FL1 mean on a hot tub?
FL1/FL2. This code means any of the following: the flow switch is malfunctioning open (FL1) or closed (FL2), the filter cartridge needs to be changed or cleaned, or there is an “air lock” condition at the circulation pump intake. The hot tub heater and jets pump will likely deactivate, so now is a great time to call a service tech.
What does the cf Code on my jacuzzi mean?
The “CF” code is simply a countdown timer that has reached zero is there to remind you to clean your filter. To reset your clean filter reminder, simply refer to “CF” reset instructions here.
Is the jacuzzi j-315 hot tub comfortable?
Although not very comfortable, it does allow you to cool your upper torso while still sitting in the water. The J-315 has only one water pump motor, but it runs in two speeds, high and low. (Other Jacuzzi models in the J-300 line have two pumps.) We tend to always use the pump on low speed.
What is the error code on my jacuzzi heater?
If you power the spa back on and these steps don’t correct the error code, it is time to start troubleshooting the circuit board, sensors, and possibly the heater or topside (though not likely). Q:My control panel reads the error code “SN1.”
Why is there no flow in my jacuzzi?
If the flow issue does not clear after solution A or B then it is possible you either have a faulty pump that is not pushing the water through or a faulty pressure/flow switch. If this is the case, we recommend calling a technician to help solve your hot tub problem.
FL1/FL2. This code means any of the following: the flow switch is malfunctioning open (FL1) or closed (FL2), the filter cartridge needs to be changed or cleaned, or there is an “air lock” condition at the circulation pump intake. The hot tub heater and jets pump will likely deactivate, so now is a great time to call a service tech.
What does it mean when your hot tub says flow error?
A hot tub flow error indicates that there is a problem with the flowing of water through the hot tub heater. Some of the most common hot tub error codes are FLO, FL1 or FL2, and are picked up by flow or pressure switches.
What is the error code for the jacuzzi?
(Playback ID: _8MxSGLGamuBFB3o) An error occurred while retrieving sharing information. Please try again later.
