What does F1 mean on a spa?
On page 29 it shows that “F1” indicates the spa is running the factory default 1 hour filtration cycle. It indicates this should run one 30-minute cycle every 12 hours.
Which is the correct error code for spa?
(Displays when first powered up after refill). Spa operating in Standard Mode. Spa operating in Economy Mode. Safety Suction, Spa is shut down. Spa operating in Standard-in-Economy Mode. Overheat Protection (Heater is deactivated, pumps low speed is activated). Spa water is more than 20° F cooler than the temperature set point.
Why does my Vita spa not turn on?
Overheating condition where a water temperature sensor has detected water temperatures of 110°F (43.3°C). Spa functioning is then disabled until temps fall below 108°F (42.2°C).Could indicate a pump operating at low speed for an extended time, constant filtering due to a programming error or a faulty pump. DO NOT GET INTO THE WATER!
What does cover guy on Vita spa stand for?
The Cover Guy provides all Vita Spa replacement covers so you are guaranteed a perfect fit every time. These are the error codes and display messages that a ThermoSpas Hot Tub may display, along with what they mean and any actions required: Stands for “Overheat”- and the tub shuts down.
What to do if your Vita spa freezes?
Take off the heat shield cover to allow the water to cool down. Make sure that the slice valves are open and reprogram the spa to make sure there are no overlapping time cycles. Open all jets. Contact the dealer or service organization if the problem continues. Sensor detects possible freeze conditions.
Overheating condition where a water temperature sensor has detected water temperatures of 110°F (43.3°C). Spa functioning is then disabled until temps fall below 108°F (42.2°C).Could indicate a pump operating at low speed for an extended time, constant filtering due to a programming error or a faulty pump. DO NOT GET INTO THE WATER!
The Cover Guy provides all Vita Spa replacement covers so you are guaranteed a perfect fit every time. These are the error codes and display messages that a ThermoSpas Hot Tub may display, along with what they mean and any actions required: Stands for “Overheat”- and the tub shuts down.
(Displays when first powered up after refill). Spa operating in Standard Mode. Spa operating in Economy Mode. Safety Suction, Spa is shut down. Spa operating in Standard-in-Economy Mode. Overheat Protection (Heater is deactivated, pumps low speed is activated). Spa water is more than 20° F cooler than the temperature set point.
What do you need to know about Vita spas?
Vita Spas designed the industry’s first hot tub that was built to be appliance grade. They also utilize a steel frame as one of the essential building blocks for each of their products. Their focus on hydrotherapy includes the same level of therapeutic relief that consumers would receive by visiting a massage therapist.
