What does error 2 on Spa quip mean?
Error 2 – Not Used. With any Error 3-8, spa operation will stop and not continue until the controller is reset. (Switched off and on again at the main power supply) This error indicates that one of the buttons in the touch pad is stuck or has been held down for more than one minute.
What to do when your spa quip SP600 says Prime failed?
Note: When in an error state the alarm can be muted by pushing the AIR/AUX button. This is not necessarily a problem with the SP600 itself, but indicates that no water is being detected in the heater housing. Prime failed is a special case in that it can be recovered from by pushing a button.
How to set spa quip for the correct day?
Hold down the button and press the button until the correct day is selected. Release both buttons. 3. Hold down the button and press the button until the correct hour is set. Release both buttons. 4. Hold down the button and press the button until the correct minute is set. Release both buttons. 5.
What does the H20 light on the spa quip mean?
The yellow or blue H20 light indicates if water is present in the heater. If no water is detected then the light will flash and the unit will not operate except to run the circulation pump to try to get water to the heater. If no water reaches the heater for one minute then an H20 error will occur.
What to do if your spa has an error code?
If the problem stays SnA, then you have a bad PC board. Same with the error SnB. Find replacement PC board. Sensors are out of balance. If this alternating with the temp, it may just be a temporary condition. If the display shows only this message (blinking), the spa is shut down. Shut the spa off for 20 min to reset the power.
What are the spa side error codes for gecko?
Gecko Spa Side Error Codes FLO Pressure switch failure, switch open FLC Pressure switch failure, switch closed Prr Temp sensor failure Prh Hi-limit sensor failure HL Sensor measuring 119 degrees
What are the error codes on the Balboa spa?
Balboa Spa Side Error Codes pd Power supply, unit running on battery ba OH Sensors reading 112-118° F. OHH Overheat. Spa has shut down. One sensor OHS Overheat. Spa has shut down. One sensor
What should I do if my spa water is 107°F?
One of the sensors has detected that the spa water is 110°F. Remove spa cover and let the water cool down. At 107°F the spa should reset. If spa doesn’t reset there is an issue with sensors or PC board. Find replacement PC board. Potential freeze conditions.
