What does eo2 mean on a whirlpool hot water heater?
E02 means that your high limit thermostat has tripped on your water heater. If the water is way too hot, then your thermostat needs to be replaced. If the water is not too hot but you’re getting an E02 error, your high limit thermostat needs to be replaced.
Are there error codes for Pentair minimax NT heaters?
Reading, understanding, and diagnosing Pentair MiniMax NT heater error codes are understandably confusing for the typical pool owner. In fact, it can be very difficult for any pool owner regardless of his/her skill set. It is simply the nature of the beast. Troubleshooting and diagnosing technical issues can be more difficult online.
What does E06 mean on a Pentair hot water heater?
** If you see the ‘E06’ error code, we recommend you contact Pentair directly and allow them to troubleshoot the unit with your over the phone. Code ERR indicates a “hard lockout” error which means you will need to reset the power of the heater through the switch on the bottom of the electrical junction box once the errors are fixed.
What does the E04 error code on a Pentair heater mean?
A couple of things can trigger the E04 error code that you should check for: The ‘E05’ error code indicates that the ignition has failed. In many cases, the heater may fire up and heat for a few minutes, but shorten out. Typically, this is caused by a bad igniter, but not always.
What does the E02 error code on a minimax mean?
The ‘E02’ error code indicates that the high limit sensor has tripped. A “High Limit” is a safety device that opens the electrical circuit and shuts off the heater based on a water temperature set point within the “High Limit Device”. The MiniMax NT heater contains (2) high limit devices which are located on the main inlet / outlet header.
What does E05 mean on a Pentair minimax NT?
I have a Pentair Minimax Nt and the E05 error is igniter/flame/pilot failure. I have the same problem with mine right now. Not sure if you all have gotten help yet, but the mastertemp E05 error code is related to the stack flue sensor and the NT is, like posted, the flame sensor code.
Why is my Pentair heater giving me the E05 error?
By the way, the heater giving me the E05 error is a Pentair Mastertemp. I have a Pentair Minimax Nt and the E05 error is igniter/flame/pilot failure. I have the same problem with mine right now.
Are there any technical issues with my Pentair minimax pool?
If you have a Pentair MiniMax NT and are experiencing technical issues, this blog is for you. One of the reasons it is so hard to diagnose technical issues online is because every pool and every heaters are different.
Why does mastertemp give me an E05 error code?
E05 error code. Not sure if you all have gotten help yet, but the mastertemp E05 error code is related to the stack flue sensor and the NT is, like posted, the flame sensor code. The NT will give this code for other reasons also, such as low gas pressure, blocked orfices or inadequate air flow.
