What does ECON mean on a hot tub?
ECONOMY mode heats the spa water during filter cycles only. For example if your spa is set for 100 degrees it will heat until the water temperature reaches 100 as long as the filter cycle is running.
Should I put my hot tub in economy mode?
Using Economy Mode Rather than heating the water consistently to maintain your set temperature, economy mode will only heat the water during your scheduled filtration times. Simply put, economy mode reduces your hot tub energy costs by running your heater less.
What mode should your hot tub be on?
By default filter modes are 2 hours in the morning and 2 hours in the evening, the rest of the time the hot tub will use the insulation to keep the spa warm and retain heat. Economy is a good setting for those who use the hot tub daily.
How does the ThermoSpas work in standard mode?
Pressing the ‘Pump 1’ button will change the mode to Standard and display the Economy-in-Standard icon. The spa will automatically revert to Economy mode after one hour (or instantly if you press ‘Mode/Prog’). Sleep Mode heats the spa to within 20° of the temperature set-point, but only during filtration cycles.
How does a hot tub control panel work?
Control Panel Operation (for additional information, please see the Special Operating Instructions for your specific hot tub) TS702 Main Control Panel Pump 1 Pump 1 is a 2 speed pump. Pressing once puts the pump into low speed, indicated on the LCD by a slow moving pump icon .
What do the warm and cool buttons do on a ThermoSpas?
Warm & Cool The warm & cool buttons are used to change the temperature set-point of the spa. When either button is pressed, “Set Temperature” is displayed on the LCD and the temperature can be adjusted. The minimum set point is 80°, while the maximum is 104°.
How to turn off pump 1 on the ThermoSpas?
Pump 1 Pump 1 is a 2 speed pump. Pressing once puts the pump into low speed, indicated on the LCD by a slow moving pump icon . Pressing a second time activates Pump 1 to high speed (icon moves faster). To turn off, press a third time (icon disappears from the LCD).
Pressing the ‘Pump 1’ button will change the mode to Standard and display the Economy-in-Standard icon. The spa will automatically revert to Economy mode after one hour (or instantly if you press ‘Mode/Prog’). Sleep Mode heats the spa to within 20° of the temperature set-point, but only during filtration cycles.
What are the error codes on the spa side?
Flow Switch (heater is deactivated. Pump may also be deactivated). Panel sensors have been pressed too many times in a short period of time. Circuit Board temperature has exceeded acceptable limit. Freeze protection. No action is necessary. Freeze protection. No action is necessary. Communication between the panel and circuit board is faulty.
Control Panel Operation (for additional information, please see the Special Operating Instructions for your specific hot tub) TS702 Main Control Panel Pump 1 Pump 1 is a 2 speed pump. Pressing once puts the pump into low speed, indicated on the LCD by a slow moving pump icon .
What does it mean when spa is in Economy mode?
Spa operating in Economy Mode. Safety Suction, Spa is shut down. Spa operating in Standard-in-Economy Mode. Overheat Protection (Heater is deactivated, pumps low speed is activated). Spa water is more than 20° F cooler than the temperature set point. Flow Switch (heater is deactivated. Pump may also be deactivated).
