What does CLK mean on Rheem pool heater?
This is what Raypak/Rheem lists as a definition for CLK on the display: “Clock – Time Clock. Heater is off by programmed control of a Time Clock.”
What are the error codes for the Rheem pool heat pump?
Rheem Pool Heat Pump Error Codes| Troubleshooting E0probe 1 fault (control) E1probe 2 fault (defrost) E2check 3 fault (cond) IAExternal Alarm dorDoor opened alarm
Why does my Rheem pool alarm go off?
Alarm off – The desired programmed temperature point is less than 60 ° F (15 ° C). LP and LP3 – Refrigerant gas shortage or faulty low pressure in the unit. Unit 3 will show (LP3) after LP fault and shut down the unit and pool pump for safety. If this happens, you should call for service.
When to call for service on Rheem pool Unit 3?
Unit 3 will show (LP3) after LP fault and shut down the unit and pool pump for safety. If this happens, you should call for service. HP and HP 6 – Low water flow or faulty high pressure control in the unit. Check water flow / backwash. Unit 6 HP will show after the defect (HP 6).
What does it mean when pool heat pump is off?
OFF – The desired programmed temperature point is lower than 60°F (15°C). LP & LP3 – Shortage of refrigerant gas in the unit or faulty low pressure control. The unit will show (LP3) after 3 LP faults and shuts down the unit and pool pump for protection. If this occurs, you should call for service.
What are the error codes on a pool heat pump?
Rheem Pool Heat Pump Error Codes Alarm code Description E0 probe 1 error (control) E1 probe 2 error (defrost) E2 probe 3 error (cond) IA external alarm
Why is my Rheem pool heat pump turning off?
OFF – The desired programmed temperature point is lower than 60°F (15°C). LP & LP3 – Shortage of refrigerant gas in the unit or faulty low pressure control.
How does the fault code work on a Raypak pool heater?
The majority of Raypak heaters will have a digital readout. The digital readout helps pool owners read error codes on the actual heater. The models with digital thermostats are programmed to display a variety of status and diagnostic messages, depending on the operating conditions. They are also equipped with onboard diagnostic controls.
What does FL3 code mean on a pool pump?
• The unit is in the protection mode and will show (FL3), press any key to restart the unit. FL3 code will stop the unit and pool pump. FS – Unit is in the defrosting cycle. (The fan works but the compressor is stopped.) Caution! Any troubleshooting involving electrical or refrigeration must only be carried out by Licensed Persons.
