What does cell reversing mean on salt cell?
AquaPure automatically cleans the Cell electrodes once every 3 hours by reversing polarity. This does not interrupt the production of Chlorine.
How do I clean my AquaPure 1400 Salt Cell?
How do you clean a Jandy plc1400?
- Remove the cell from the Jandy AquaPure Purification System.
- Remove the sensor from its port on the cell if scaling is detected.
- Wash the cell well with water.
- Turn the flow/temp/salinity sensor counterclockwise to remove it from the three-port cell.
How often does no flow and cell reversing stay on?
Since we opened our pool this year we have had problems. Originally the Flow would lite up but them switch to no flow. Now, No Flow seems to stay all 99% of the time. The Flow will occasionally light up but them switch back to No Flow. Now, the cell reversing light stays on for long periods of time.
How to clear memory on Jandy aquapure 1400?
Disconnect power to the Jandy controller and then disconnect the four wire com cable from the Aqua pure and turn controller back on, wait till it boots, then turn it off. Connect the com wire agian and turn the controller back on and see if it sees it then. If not, clear the memory.
What to do when no flow on Jandy aquapure?
There is no chlorine produced when it says no flow. We have cleaned the sensors with green scrub pad from kitchen. We have cleaned the Cell with Cell cleaner. We have used Filterbrite and backwashed etc.
How old is the sensor on the Jandy aquapure?
The sensor is only about a year and a half old. The Chlorine cell is about 4 years old. I cleaned the cell (some build up but not bad at all just a light coating).
Since we opened our pool this year we have had problems. Originally the Flow would lite up but them switch to no flow. Now, No Flow seems to stay all 99% of the time. The Flow will occasionally light up but them switch back to No Flow. Now, the cell reversing light stays on for long periods of time.
Disconnect power to the Jandy controller and then disconnect the four wire com cable from the Aqua pure and turn controller back on, wait till it boots, then turn it off. Connect the com wire agian and turn the controller back on and see if it sees it then. If not, clear the memory.
There is no chlorine produced when it says no flow. We have cleaned the sensors with green scrub pad from kitchen. We have cleaned the Cell with Cell cleaner. We have used Filterbrite and backwashed etc.
What is the temperature code on the Jandy flow sensor?
Now getting the magic 172/185 code “flow salinity sensor temperature probe error codes”. I’m on my 15th minute of hold for Jandy tech support (once again) to see if there are further tests I can run or if the flow sensor is defective as suggested in the manual.
