What does an aquapure do in a pool?
AquaPure is a salt chlorine generating system used to sanitize your pool, using a closed-loop water-softening system.
What should the chlorine content be on a Jandy aquapure?
Chlorine stabilizer content should be 50 to 75 PPM. For every 50 pounds of salt, 1.25 pounds of stabilizer should be added. Increase the system’s daily operating time. Increase chlorine production by pressing the “chlorine production rate adjustment” button. Enable “boost” mode and run for 24 hours. Press the “test salinity” button.
Why is my salt water system not producing any chlorine?
The salt level is a critical factor and if the salt level is too low in your pool the SWG will not be able to produce chlorine. Most system need at least 3000 ppm of salt in the water except for the Hayward Aqua Rite which can operate with as little as 2600 ppm.
How to troubleshoot a Jandy aquapure power supply?
If salinity is low, more salt may need to be added. Clean the cell if it is dirty or clogged. Check that the unit is connected to a power supply and the pump is switched on. Fully insert into the connector the ribbon cable between front and back PC board. Properly connect the connector at the white plug between the transformer and back PC board.
AquaPure is a salt chlorine generating system used to sanitize your pool, using a closed-loop water-softening system.
Chlorine stabilizer content should be 50 to 75 PPM. For every 50 pounds of salt, 1.25 pounds of stabilizer should be added. Increase the system’s daily operating time. Increase chlorine production by pressing the “chlorine production rate adjustment” button. Enable “boost” mode and run for 24 hours. Press the “test salinity” button.
If salinity is low, more salt may need to be added. Clean the cell if it is dirty or clogged. Check that the unit is connected to a power supply and the pump is switched on. Fully insert into the connector the ribbon cable between front and back PC board. Properly connect the connector at the white plug between the transformer and back PC board.
How much chlorine to add to salt water?
While some problems are technical enough that they require the attention of a qualified professional, others have a simple solution and you might be able to troubleshoot these yourself. Add chlorine stabilizer as required. Chlorine stabilizer content should be 50 to 75 PPM. For every 50 pounds of salt, 1.25 pounds of stabilizer should be added.
