What does a flow switch do on a pool?
The flow switch is designed to prevent such a scenario by allowing the device to produce chlorine only when sufficient water flow is detected in the pipeline. For optimal results, the flow switch should be installed correctly: the flow switch MSUT be installed before the electrolysis cell.
What does no flow mean on Aqua rite pool?
The no flow would tell us that the switch is not engaging. Check the wire going from the flow sensor in the pipe to the control box, if the wire is cut (either chewed by an animal, hey it happens, or weed wacked by careless grounds keepers) then you can try a splice.
How to diagnose a Hayward Aqua rite flow switch problem?
The NO FLOW LED stays ON when there is a flow switch problem. 1 Verify if your flow switch was installed correctly. 2 The arrow at the top of the hex nut points in the direction of the water flow. 3 Flow switches require a minimum flow fate of 11 gallons per minute to stay consistently closed 4 Check for damaged or cut wires
How to check the flow of an aquarite?
1. Check Salt & Inspect Cell: flashing or ON 16-18 2. High Salt: LED ON 19-22 3. No Flow: LED flashing or ON 23-26 4. Display ONLY, Lights ONLY, or Neither 27 5. LCD: Displaying HOT or COLD 28 Additional Information: Pg. 29-32 Salt Addition Table 30 Chlorine Output & Salt Levels 31-32 3 AquaRite: How It Works
How to troubleshoot an aqua rite with a fuse?
Power LED Not On 1 Make sure that either 120VAC or 240VAC input power is connected to the proper screw terminals at the Aqua Rite control. 2 Verify input voltage with a voltmeter 3 If there is input power, the fuse may have blown. 4 The Aqua Rite is protected by a 20 amp mini ATO fuse located on the circuit board above the cell connector.
What should I do if my Aqua rite light is flashing?
Page 8 If LED is flashing, wait 60 seconds after starting filter pump. Check for possible turbulence inside of flow T. Installation requires 12 inches of straight pipe before flow switch. There should be no elbow after the flow switch. O HAYWARD No LED’s/LCD display Verify 220-240 VAC or 115-125 VAC at input terminal TBI.
How to troubleshoot an aqua rite filter pump?
Check for damaged or cut wire. Page 8 If LED is flashing, wait 60 seconds after starting filter pump. Check for possible turbulence inside of flow T. Installation requires 12 inches of straight pipe before flow switch. There should be no elbow after the flow switch. O HAYWARD
The no flow would tell us that the switch is not engaging. Check the wire going from the flow sensor in the pipe to the control box, if the wire is cut (either chewed by an animal, hey it happens, or weed wacked by careless grounds keepers) then you can try a splice.
What does the no flow light on Hayward Aqua rite mean?
The ‘No Flow’ light is an indication that there is something funny going on with the flow in your piping or the flow switch itself. If there is an issue with the flow, the ‘No Flow’ light will flash up to 60 seconds at start up. If none of the below remedies solves your issue, you may need to replace your flow switch.
