What does a control panel on a hot tub do?
A spa control panel is a window of information to the spa or hot tub it is installed in. Usually these systems are the brain of the unit and regulate its functioning.
What should I do if my spa control panel is not working?
The connections should be inspected to ensure they are straight and sitting in place tightly. The breaker can be turned on again allowing the spa control system to reboot. If this does not help and since the sensors are brand new with no signs of defect, the problem could be a faulty circuit board.
What to do if your hot spring spa is not working?
Contact the dealer or service technician if the problem continues. Indicates faulty communication between the spa’s control panel and circuit board and/or remote control panel. Contact the dealer or service technician. Stands for “Sensor 1” and displays when the high-limit sensor is malfunctioning.
What to do if your hot tub control panel is frozen?
If part of the control panel is dead or the whole panel is frozen, you will want to see if the problem is the circuit board or the control panel. Examine the panel to see if any moisture is present inside the display. See if the panel or any buttons are cracked or if it could have possibly gotten wet.
Is the hot tub control system the same as the spa?
Note: The control system brand name is usually different from the hot tub brand name. You can often determine the make of the control system by looking inside the spa’s equipment area. Disclaimer: Although we hope this information will be useful, error codes are subject to change without notice.
Where is the control panel on my hot tub?
For a control panel that is built into the hot tub if you have a look inside the service bay of the hot tub you will probably see that it is also connected to the hot tub via a cable which will no doubt be plugged in somewhere. Again check for corrosion.
What does it mean when your spa unit is out of sync?
Means that the spa unit will need to be reset. This message might appear with another message. Reset by depressing any button located on the top side panel. The temperature sensors are not in balance and are more than likely are out of sync by 2°F – 3°F.
What does cold mean on a spa heater?
CoLd = Temperature in the spa heater housing is below 40° F. Status of the heater element is unknown. The low speed pump or circ pump will operate continuously until the temperature rises above 45° F. OH = Over heat. The spa is at a temperature above 108° . Do not use spa when temperature is flashing or the OH message is displayed.
