What does 60 mean on Hayward pool heater?
The “60” code is really “bO” meaning “bypass operation” in which your heater’s internal thermostat is bypassed so as to control the set temperature by your remote. LO means the limit string is open. Most likely culprit is the pressure switch.
Why is smoke coming out of my pool heater?
If your pool heater is either black on the top or producing black smoke when it is running, this is due to low gas pressure or poor air supply and venting. If you notice smoke coming from your electric water heater, there is probably a problem with the electrical wiring inside the service panel.
Is the Hayward pool heater made of gas?
The components of a Hayward pool heater are also very similar to gas heaters made by other manufacturers. To troubleshoot a gas-fired appliance, you have to think like a “combustioneer”.
How to troubleshoot a Hayward Universal pool heater?
Troubleshooting chart for Hayward Universal H-Series electronic pool heaters with a digital display, models H150, H200, H250, H300, H350, H400 INPSECT WIRES FOR KINKS OR RODENT DAMAGE. INSPECT TERMINALS FOR BREAKAGE OR CORROSION REMOVE WIRES AND MEASURE OHMS WITH PUMP ON; IF CLOSED – SWITCH IS OK. IF OPEN, RECONNECT WIRES & PROCEED.
How can I troubleshoot my pool heater problem?
Troubleshooting pool heaters is a methodical process; or a process of elimination really. First eliminate water flow issues, then gas flow issues, and finally the low voltage electric currents that run between pool heater components.
What to do if your pool heater is undersized?
If your heater is undersized, it will have problems heating your pool up. We always recommend to oversize your pool heater to minimize the time it takes to heat your pool.
Troubleshooting chart for Hayward Universal H-Series electronic pool heaters with a digital display, models H150, H200, H250, H300, H350, H400 INPSECT WIRES FOR KINKS OR RODENT DAMAGE. INSPECT TERMINALS FOR BREAKAGE OR CORROSION REMOVE WIRES AND MEASURE OHMS WITH PUMP ON; IF CLOSED – SWITCH IS OK. IF OPEN, RECONNECT WIRES & PROCEED.
Do you need a fireman’s switch on a Hayward pool?
This was to allow the water to cool down and not damage the plumbing lines. ALL Hayward heaters have Fire Tile, which dissipates the heat immediately, so a fireman’s switch is not required. NOTE: Gas fired heaters should be diagnosed and repaired by trained personnel. What power supply do I need?
The components of a Hayward pool heater are also very similar to gas heaters made by other manufacturers. To troubleshoot a gas-fired appliance, you have to think like a “combustioneer”.
What are the most common problems with pool heaters?
One of the most common problems with pool heaters is it failing to ignite. Is your heater turned ON and the temperature set correctly? Ensure that the thermostat is set to a higher temperature than the current water temperature. Is your pump running with a clean filter and basket? Inspect the pump and filter and clean if necessary.
