What does 5n mean on a hot tub?
This is usually caused by low flow through the Heater. You could check and clean the filters and make sure your pump is operating properly. You may need to reset the code by turning off the power to your spa for about 5 min then back on.
Why does my hot tub switch off?
So, why does my hot tub keep tripping and turning off? The problem could be due to a worn GFCI breaker, moisture or corrosion inside the breaker box, damaged or loose wiring, or malfunctioning components. It could even be down to a bad heating element or a flooded blower.
What are the error codes on the spa side?
Flow Switch (heater is deactivated. Pump may also be deactivated). Panel sensors have been pressed too many times in a short period of time. Circuit Board temperature has exceeded acceptable limit. Freeze protection. No action is necessary. Freeze protection. No action is necessary. Communication between the panel and circuit board is faulty.
What does it mean when your Spa is deactivated?
Freeze protection. No action is necessary. Communication between the panel and circuit board is faulty. Watchdog” (spa is deactivated) A problem has been detected. Open sensor (heater is deactivated) or Shorted sensor (spa is deactivated). Open or shorted sensor ( heater disabled).
What does open sensor on spa water mean?
Open sensor (heater is deactivated) or Shorted sensor (spa is deactivated). Open or shorted sensor ( heater disabled). Overheat Protection (Heater is deactivated, pumps low speed is activated). Spa water is more than 20° F cooler than the temperature set point.
What’s the difference between Spa and standard mode?
Spa operating in Standard Mode. Spa operating in Economy Mode. Safety Suction, Spa is shut down. Spa operating in Standard-in-Economy Mode. Overheat Protection (Heater is deactivated, pumps low speed is activated). Spa water is more than 20° F cooler than the temperature set point. Flow Switch (heater is deactivated. Pump may also be deactivated).
What to do if your hot tub has an error code?
To do this, either turn the wheel or the screwdriver slot on the pressure switch counter-clockwise one full turn (two at the most). If this does not make the code go away, then send the board in for repair or replace it. See complete list of error codes here.
Is there an error code on my hot spring?
So, when you see an error code on your spa’s control panel, you might worry that you’ve lost your chance. But don’t fret! Hot Spring ® spa systems are reliable and will last a long time with regular maintenance, but issues do sometimes arise.
How can I troubleshoot my Spa circuit board?
Check all of the bits on the board for any signs of damage, looking closely also at the wire or cable connection points on the board. Check that all the wire connections are tight, and look for any signs of water damage to the board. Some damage may be only visible on the opposite side of the board.
What does it mean when your hot tub is out of danger zone?
A freeze condition has been detected by the system. The jet pumps operates until the water is warmed and spa is out of danger zone. No action is needed. Note that this message may occur when the hot tub is filled for the first time because tap water is usually very cold. Indicates a hot tub power failure.
