What comes with a new toilet tank?
Most tanks come with bolts, washers and nuts. The rubber washer goes inside the tank, and the metal washer and nut go on the end of the bolt. If your tank does not come with these parts, you can reuse the old bolts, or they can be purchased at most hardware stores.
What’s the best way to install a new toilet?
How to Install a New Toilet. Tighten one end of a stainless-steel water-supply line to the shutoff valve. Connect the other end to the fitting on the underside of the toilet tank. 23. Open the shutoff valve to fill the toilet tank with water. 24. Put the lid on the tank, then flush the toilet to check your work.
What are the parts you need to replace a toilet?
Below are some parts for toilet replacement/repair. Now that you have all the necessary parts, you are ready to get started with the replacement! Make sure you have an adjustable wrench on hand to help with the bolts. A toilet consists of two parts: the tank and the body. The tank is on top, so you must remove it before the body.
What should I do when I need to replace my toilet tank?
When you need to replace the tank, drain and unscrew the old one to remove it. After getting your new tank, put in the hardware to waterproof it and then secure it in place. Once the tank fills up with water, you can use your toilet again!
How to install a gasket on a Kohler toilet?
This video will show you how to install the tank gasket (GP51487) and toilet tank on most KOHLER two-piece toilets. If playback doesn’t begin shortly, try restarting your device.
How to install a toilet tank at Home Depot?
1 If not already attached, install the “tank to bowl” gasket onto the base of the flush valve. 2 Place the tank onto the bowl, aligning the shank of the bolts with the holes in the bowl. 3 Secure the tank to the bowl by alternately tightening each tank bolt until the tank pulls down and meets the bowl.
Below are some parts for toilet replacement/repair. Now that you have all the necessary parts, you are ready to get started with the replacement! Make sure you have an adjustable wrench on hand to help with the bolts. A toilet consists of two parts: the tank and the body. The tank is on top, so you must remove it before the body.
When you need to replace the tank, drain and unscrew the old one to remove it. After getting your new tank, put in the hardware to waterproof it and then secure it in place. Once the tank fills up with water, you can use your toilet again!
How do you install a Kohler toilet tank?
Kohler toilet tanks use a technique called the DryLock method to install their toilet tanks. Instead of drilling holes at the bottom of the toilet tanks, Kohler installs a bracket underneath the toilet tank where bolts are hooked. This method uses three bolts. You simply straighten the bolts from the bracket and install the tank on the bowl.
