What causes high pool pump pressure?
High swimming pool filter pressure is usually the result of a lot of particles being filtered out of the swimming pool water. When pressure rises it is time to backwash the filter if you have that option with a sand or diatomacesous earth (DE) filter.
Why is my pool pump PSI low?
When the pressure is lower than normal, this usually indicates a flow problem, and usually something is blocking or restricting water flow into the pool pump. It’s never a problem after the pool pump, because after the impeller, the pool water is under pressure, and obstructions result in higher than normal pressure.
What should the pressure be on my pool pump?
Pressure went down to 15 psi, then I put the filter cartridge back in, pressure was still 15 psi, everything seemed good. That was one week ago. I checked again today, and the pressure was back up to 30 psi!
When to clean a 30 psi pool pump?
We generally recommend cleaning when the pressure goes up 20-25%. So that would would be around 19psi not 30. Although for now I think John is right. Likely they have scaled up and clogged and need a good thorough soaking and cleaning. Click to expand…
Is it normal to have 30 PSI pump pressure?
You can use half pool and half tap water to start the test and then double the reading to get a little better idea. First step with high CYA is a lot of water replacement to lower the CYA. And then you must stop using the tablets which are adding the CYA. Dave makes a good point about the scaling.
Why does my pool pump have a low PSI?
SUCTION LEAK AT PUMP (Low PSI) – The pump lid o-ring, pump intake fitting, and drain plugs are common areas to draw in air. A suction leak in the suction side of the pump can cause a number of problems. If it’s large enough, too much air will be sucked into the system, and the pump will lose prime.
Pressure went down to 15 psi, then I put the filter cartridge back in, pressure was still 15 psi, everything seemed good. That was one week ago. I checked again today, and the pressure was back up to 30 psi!
We generally recommend cleaning when the pressure goes up 20-25%. So that would would be around 19psi not 30. Although for now I think John is right. Likely they have scaled up and clogged and need a good thorough soaking and cleaning. Click to expand…
SUCTION LEAK AT PUMP (Low PSI) – The pump lid o-ring, pump intake fitting, and drain plugs are common areas to draw in air. A suction leak in the suction side of the pump can cause a number of problems. If it’s large enough, too much air will be sucked into the system, and the pump will lose prime.
You can use half pool and half tap water to start the test and then double the reading to get a little better idea. First step with high CYA is a lot of water replacement to lower the CYA. And then you must stop using the tablets which are adding the CYA. Dave makes a good point about the scaling.
