What are the safety instructions for ProSeries high rate sand filter?
ProSeries™HIGH RATE SAND FILTERS Owner’s Manual MODELS S210S, S244S, S310S IMPORTANT SAFETY INSTRUCTIONS Basic safety precautions should always be followed, including the following: Failure to follow instructions can cause severe injury and/or death. This is the safety-alert symbol.
What to look for in sand filter owner’s manual?
SAND FILTERS Owner’s Manual MODELS S210S, S244S, S310S IMPORTANT SAFETY INSTRUCTIONS Basic safety precautions should always be followed, including the following: Failure to follow instructions can cause severe injury and/or death. This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for
What are the parts in a Hayward sand filter?
IS210S1 Rev A USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 1 ProSeries™HIGH RATE SAND FILTERS Owner’s Manual MODELS S210S, S244S, S310S IMPORTANT SAFETY INSTRUCTIONS Basic safety precautions should always be followed, including the following: Failure to follow instructions can cause severe injury and/or death.
How do you run a sand filter in a flowclear?
Plug in and run the sand filter for 3-5 minutes, or until the water runs clear. 3. Switch off the sand filter and set the Control Valve to the Rinse function. 4. Switch on the sand filter and run the sand filter for 1 min. This circulates water backwards through the sand filter and drains water out Port D. 5. Switch off the sand filter.
How does a top mount sand filter work?
Top Mount Sand Filters are supplied with a screw down Multiport Valve. Supplied with the Multiport Valve are Flange clamp, screws and O-ring. 1. Screw the barrel unions onto the threaded ports on the Multiport Valve. 2. When rotating the Multiport Valve into position on a Top Mount Filter, leave some leeway for better alignment of plumbing. 3.
How do you fill a sand filter vessel?
1. Before filling the filter media into the filter vessel, do a visual check of the laterals. Look for broken or loose laterals. Replace if necessary. 2. To eliminate stress on the laterals, fill the filter vessel with enough water to provide a cushioning effect when the filter sand is poured in. Installation of the Multiport Valve 3.
What should water temp be for sand filter?
Blow molded Sand Filters are designed to work with water at a temperature > than 0º C (32 º F) and < than 45ºC (113 º F). The filter should never be operated outside of these temperatures or damage may occur. 2.
Where to place sand filter in swimming pool?
1. Position the filter as close to the Swimming Pool/ Spa as possible. 2. Position the filter so that it is not in or near areas that are prone to flooding 3. Position the filter so that the piping connections, Multiport Valve and winter drain is convenient and accessible for operation, servicing and winterizing. 4.
