What are the error codes on the Pentair pump?
Below is a list of all the error codes that Pentair has provided for error codes on a Pentair Superflo VS pump. These codes are a great way to do a simple diagnostic to see what issues your pump is having.
What does 1A mean on a Pentair pump?
1A – Power Module over current detected: If this error displays multiple times, then there may be a problem with the pump’s rotating assembly. Please disassemble the pump and investigate to see if there is a problem with the impeller or mechanical seal.
Why is my Pentair Superflo pump not working?
Ensure that the 5 pin connector is properly plugged into the socket and that there is no damage to the cable. 1A – Power Module over current detected: If this error displays multiple times, then there may be a problem with the pump’s rotating assembly.
Why do we need a Pentair pool pump?
Our energy efficient pool pumps help conserve energy resources and reduce energy costs. Enjoy straight-from-the-tap refreshment with the Pentair FreshPoint Easy Flow Filtration System. We work every day to help people move, improve and enjoy water.
Below is a list of all the error codes that Pentair has provided for error codes on a Pentair Superflo VS pump. These codes are a great way to do a simple diagnostic to see what issues your pump is having.
What causes an E05 error on a Pentair pool?
E05 Error Code Pentair Mastertemp. 1 Answer. E05: E05 errors can be due to things like a sooted exchanger(fuel delivery, venting), scaled up exchanger (water side), or a low water flow.
How to troubleshoot a Pentair pool heat pump?
Troubleshooting Guide For Pentair Pool Heat Pumps 1. Low refrigerant in system. Find source of refrigerant leak and fix. Pull vacuum and recharge. 2. Air and water temperatures too cold to operate the heat pump. 3. Bad refrigerant low pressure switch. Check resistance of switch with a full charge,
How does the ERR 0002 work on a Pentair Superflo?
The Err 0002 will prevent the pump from running until you clear the blockage. So, if the pump is on, hit the start/stop button to turn it off. There are two ways to clear the blockage. The method I always use is to remove the pump lid and pump basket, then I spin the impeller with a screwdriver.
