What are the electrical requirements for a spa?
Hot Tub Electrical Requirements
- The electrical connection to the hot tub must be single phase, 220-240 volt 4 wire.
- A shoe box sized metal box, called a disconnect box, must be installed no closer than 5 feet from the hot tub and no further than 15 feet and must be easily accessible to the hot tub users.
What is the error code for the spa?
PSoL = Pressure switch open with low pump. PSoH = Pressure switch open with high pump. ToE = Time out error. Rare system error. Spa unusable. Contact ACC. OHH = Overheat. Spa has shut down. One sensor has detected 118º Fat heater. OHS = Overheat. Spa has shut down. One sensor has detected 110ºF. SnA = Spa is shut down.
How to reset spa message on calspas.com?
Press any button to reset or wait 15 minutes and spa will automatically reset. If message spa does not reset, call customer service. Insufficient water detected in heater. Spa is shut down. (Displays on third occurrence of dr message.) Follow directions for dr message and press any button to reset spa.
Why does my spa not reset when dry or dy?
Spa will not automatically reset when dry or dY is displayed. A difference in readings between temperature sensors has been detected indicating a possible water flow problem. Make sure spa is filled to proper level and that pumps are primed and filter cartridges are clean.
What does it mean when your spa sensor is out of balance?
Sensors out of balance. If alternating with temp, may be temporary condition. If display shows only this message (blinking) spa is shut down. Substantial difference between temperature sensors detected. Could indicate a flow problem. Persistent low flow problems. (Displays on the 5th occurrence of “HFL” message with 24 hours).
CIRCUITS USED FOR THE SPA MUST BE DEDICATED – no other appliances, lights, etc. should be on these circuits at any time. WIRES GOING TO YOUR SPA MUST BE THE APPROPRIATE GAUGE FOR YOUR SPA.
What makes spa electrics the company it is?
Spa Electrics believes its success is the result of strong family values and commitment to quality, innovation and service excellence. There is a vibrant culture based on passion and dedication that operates on a solid foundation of mutual respect across all levels of the business.
How long is the electrical cord for a spa?
Total supplied cord length is 15 feet. Placement of spa will determine how close spa will need to be placed to reach outlet. Please refer to the ‘PREP’ tab on this site’s page for your particular spa model to see the cord placement. The cord will be connected to the ‘Control Pack’.
What kind of heater does spa builders use?
Spa Builders AP-1400 Spa Pack with 5.5kW Heater and Time Clock. This pack can operate at 120v or 230v. Spa Pack Features: Slightly Larger than AP-4 Pack Universal Air Switch Control Replacement Runs… DSICONTINUED Heater Housing PVC Housing for Mr. Spa 1.25 FIPT x .75 FIPT x .75 FIPT .
