What are the dimensions of down east Spas?
Page 29: Down East Spas Specifications DOWN EAST SPAs – SPECIFICATIONS Electrical Water Weight Therapy Model Dimensions Required Capacity Dry/Full Pumps Count Somerset 66”x 84”x 32” 240V 50A 215 gallons 515lbs/ 1791lbs Cape Cod 84”x 84”x 36” 240V 50A 425 gallons 715lbs/ 4115lbs Exeter 84”x 84”x 36”…
How to set the temperature on a Down East spa?
SPA – CONTROLS: TEMPERATURE AND TEMP RANGE Down East Spas ADJUSTING THE SET TEMPERATURE When using a panel with Up and Down buttons (Temperature buttons), pressing Up or Down will cause the temperature to flash. Pressing a temperature button again will adjust the set temperature in the direction indicated on the button.
What are the spa controls on Master spas Down East?
SPA – CONTROLS: HOLD (STANDBY) Down East Spas HOLD MODE Hold Mode is used to disable the pumps during service functions like cleaning or replacing the filter. Hold Mode will last for 1 hour unless the mode is exited manually. SPA – CONTROLS: ADJUSTING FILTRATION Down East Spas MAIN FILTRATION Filter cycles are set using a start time and a duration.
What to do if your spa has an error code?
If the problem stays SnA, then you have a bad PC board. Same with the error SnB. Find replacement PC board. Sensors are out of balance. If this alternating with the temp, it may just be a temporary condition. If the display shows only this message (blinking), the spa is shut down. Shut the spa off for 20 min to reset the power.
Page 29: Down East Spas Specifications DOWN EAST SPAs – SPECIFICATIONS Electrical Water Weight Therapy Model Dimensions Required Capacity Dry/Full Pumps Count Somerset 66”x 84”x 32” 240V 50A 215 gallons 515lbs/ 1791lbs Cape Cod 84”x 84”x 36” 240V 50A 425 gallons 715lbs/ 4115lbs Exeter 84”x 84”x 36”…
Where is the GFCI test on Master spas Down East?
SAFETY INSTRUCTIONS ImpORTaNT SafeTy INSTRUcTIONS (cONT.) (For units with GFCI) WARNING – This product is provided with a ground-fault circuit interrupter locat- ed on the front panel of selected swim spas and on the power cord of 120 volt convertible spas. The GFCI must be tested before each use.
SPA – CONTROLS: HOLD (STANDBY) Down East Spas HOLD MODE Hold Mode is used to disable the pumps during service functions like cleaning or replacing the filter. Hold Mode will last for 1 hour unless the mode is exited manually. SPA – CONTROLS: ADJUSTING FILTRATION Down East Spas MAIN FILTRATION Filter cycles are set using a start time and a duration.
SPA – CONTROLS: TEMPERATURE AND TEMP RANGE Down East Spas ADJUSTING THE SET TEMPERATURE When using a panel with Up and Down buttons (Temperature buttons), pressing Up or Down will cause the temperature to flash. Pressing a temperature button again will adjust the set temperature in the direction indicated on the button.
