What are broken laterals in a pool?
A broken lateral may have an obvious break or crack somewhere along the tube. In some cases, the damage could be a small slit that’s not as obvious, so it’s a good idea to inspect each lateral. It’s important to note that seeing some sand after backwashing your filter does not mean you have a broken lateral.
What’s the best way to replace pool filter laterals?
Remove all the sand on the inside using a wet-dry vacuum or a plastic cup. Try to avoid contact with the center pipe so it does not break or sand does not fall inside. Continue to remove sand until the laterals become visible. If you are using the same sand again, place it in a large bucket. If not, discard it in a location.
Do you need to replace sand filter laterals?
Replace a pool pump lateral to keep your water clear and sand filter running properly. Purchasing a home with a pool adds a lot of responsibility and maintenance. Sand pool filters have a star-shaped section at the bottom that includes 10 extension bars known as laterals.
How are the laterals on a hurlcon pool filter removed?
Following on from my previous question regarding sand removal, does anyone have experience with folding and removing the laterals on Hurlcon RX280 sand filter. I have looked at DIY videos etc on this and understand the laterals should fold up to the centre pipe and allow the entire arm to be pulled out thru the top of the filter.
When to replace laterals on a pool pump?
Over time, the pressure from sand and regular wear could cause a lateral to break. When this occurs, your pool pump’s efficiency will go down, and sand may enter the pool. It’s a good idea to examine and replace these parts when you open your pool for the first time in a new home. Turn off the electric pool pump and unplug it.
Remove all the sand on the inside using a wet-dry vacuum or a plastic cup. Try to avoid contact with the center pipe so it does not break or sand does not fall inside. Continue to remove sand until the laterals become visible. If you are using the same sand again, place it in a large bucket. If not, discard it in a location.
Replace a pool pump lateral to keep your water clear and sand filter running properly. Purchasing a home with a pool adds a lot of responsibility and maintenance. Sand pool filters have a star-shaped section at the bottom that includes 10 extension bars known as laterals.
Over time, the pressure from sand and regular wear could cause a lateral to break. When this occurs, your pool pump’s efficiency will go down, and sand may enter the pool. It’s a good idea to examine and replace these parts when you open your pool for the first time in a new home. Turn off the electric pool pump and unplug it.
How do you replace a sand filter in a drain tank?
Drain tank and remove sand, as described above. Fold up the laterals vertically, or unscrew threaded laterals from hub. Snap in or screw in your new sand filter laterals. Cap the standpipe, and pour the sand back in, or use new sand. Replace valve or dome securely, start up filter on Rinse.
