Should you shock your spa after each use?

Should you shock your spa after each use?

If you are using the 2-part bromine sanitizing system such as Rendezvous® Enhance and Activate, it is recommended that you shock each time you finish using your spa. If you are using chlorine or bromine tablets, it is recommended that you shock at least one time per week.

How do I reset my Hydro spa hot tub?

How to Reset a Spa Heater

1. Locate the spa’s high-limit reset. This is a red button found on many spa packs.
2. Press the high-limit reset button.
3. Turn on your spa and observe its operation.
4. Flip the breaker panel switch on or press the reset button on the GFCI outlet to restore power.

How long does it take for spa shock to work?

Recommendations vary with ranges between 20 minutes and 24 hours. When using a non-chlorine shock treatment the product does not sanitise, therefore you can generally use your hot tub 20 minutes after adding it to the water.

Why is my spa not plugged into the mains socket?

Electrical issue. Can occur when the spa is not plugged into a mains socket. May also be an issue with the RCD socket. Plug the pump unit directly into a mains socket and not into an extension lead. Issue with water flora sensors due to debris build up. The stopper caps are still inside the spa.

Where do I find the error code on my spa pump?

Error code for issue where the electrical signal within the pump body between the control panel and power board has become disconnected. This error code can become visible on 2017 model pumps and newer. The date of the spa pump can be located on the silver sticker on the pump body itself (S/N Number) or engraved within the handles.

What to do if your Lay z spa pump is leaking?

Water Leakage. Error code for an issue with water leaking within the body of the pump. Check the couplings on the pump connections to ensure there is no water leaking from these. Also ensure the washers within these are flat. These can be checked using a screwdriver and simply unscrewing the coupling.

What to do if you have too much salt in your spa pump?

High salt alarm. Alarm where too much salt has been added to the spa or a large amount of water has evaporated. Do not use the spa or place any further Pure Spa Salt for 24 to 48 hours to ensure the levels reduce. Unplug the spa pump, remove from the liner and drain 20% of the water from the spa. Refill this with fresh water.

When to buy a hot tub from a reputable dealer?

When you buy a hot tub from a reputable Hot Spring dealer, your package includes access to a wealth of expert knowledge and certified technicians who can ensure the best possible outcome when your spa experiences problems. So, plan a visit to your showroom today.

How to fix water quality in your hot tub?

FIX YOUR HOT TUB’S WATER QUALITY PROBLEMS 1 Clean the filters 2 Shock the spa water with sanitizer 3 Add sanitizer as your owner’s manual recommends; adjust the pH and/or the alkalinity to the recommended range 4 Run the jet pumps and clean the filters 5 Drain and refill the spa More

Why is there no power in my hot tub?

Consult an electrician to find the source, if not readily apparent (burnt wires, water, insects or rodent damage, etc.). Some spas and hot tubs have internal fuses, which are meant to blow when voltage spikes occur. These fuses protect your spa equipment, including pumps, blowers and heaters.

Where can I buy parts for my hot tub?

Purchase authorized Hot Spring parts from your dealer to ensure that you’re outfitting your spa with quality, lasting components. Keep your spa’s serial number on hand in case you need to reference it for more troubleshooting advice or official parts and repairs.