Is water heater pilot light on?
It’s usually right on the panel. Turn and hold the knob to “Pilot” and push the ignitor. You should hear it click, and probably also a “whooshing” sound. Check in that gap, and you should see the light on.
What should my gas water heater be set at?
120 degrees Fahrenheit
The Consumer Product Safety Commission (CPSC) recommends setting the water heater at no more than 120 degrees Fahrenheit (49 degrees Celsius) to prevent scalding. Not to mention, a water heater that is set too high can unnecessarily increase your electricity bill. Of course, every house is different.
How do I check the pilot light on my water heater?
Open the door/cover over the pilot light access. This will be located under the gas valve; some water heaters just have an open gap instead where you can see the pilot light burner. Use a flashlight or a headlamp to find the burner inside. Two small gas tubes will lead to it.
How does a pilot light go out on a water heater?
Some of the most common reasons that water heater pilot lights go out include: A faulty thermocouple. Your thermocouple is responsible for sensing when your pilot light is lit. If it senses that the pilot light has gone out, the thermocouple shuts off the gas supply to the flame in order…
How do you light the pilot light on a heater?
Here is how to light the pilot light on a gas heater. Lighting the pilot light on a gas heater is simple to do. Turn the thermostat to its lowest setting. Turn the gas knob to the OFF setting and wait 5 minutes to clear out any gas.
What if the pilot goes out on a gas heater?
Gas heaters, whether they warm up air or water in a home, rely on a pilot light to trigger the flame of the actual heater . If this pilot light ever goes out, the heater has no way of actually turning on to heat the water or air that your particular type of heater circulates to warm the house or other elements.
