Is tile good for second floor?
No, tiles are not too heavy for a second floor because tiles are generally a lightweight material distributed over an even load.
Does toilet flange sit on subfloor or tile?
5 Answers. The toilet flange needs to be on top of the finished floor. Meaning the bottom edge of the flange needs to be on the same plane as the toilet. So if your toilet sits on the tile, the flange needs to be on top of the tile too.
Can I tile my upstairs?
Ceramic tile flooring is one of the best choices you can make for your upstairs bath. Not only is it one of the most durable flooring materials you can choose from, but it’s also one of the most waterproof.
Can a tile floor be raised for a toilet?
Even 1/4-inch-thick tile over a layer of thin-set adhesive can leave the toilet flange far enough below finished floor level to make it difficult to get a good seal. Two wax rings might get the job done, but a well-sealed toilet is one of those things it isn’t wise to gamble on. A better solution is to raise the height of the flange.
How do you install a self closing toilet?
Trim closet flange bolts using linesman pliers. Then add the self-closing toilet seat…which is super easy. Place the rubber gaskets on the seat’s hinges, then the metal washers (Steve explains which ones to use in the video), and secure the seat to the bowl with the plastic nuts & washers. This new toilet took about 1 hour to install.
Can you put tile on the second floor?
In fact, tiling on a second floor is the same as tiling on any wood subfloor, whether it’s the first floor, third floor or second floor. Locate a pipe that goes through the floor. If there is no pipe, drill a hole through the floor, using a power drill.
Can a cast iron toilet be installed on a tile floor?
It’s simple, the watertight seal between the toilet bowl and wax ring will eventually fail. In order for this not to happen the toilet flange must sit above the finished floor by at least 1/4″. Steve used an Oatey 4″ replacement toilet flange for cast iron pipes.
Trim closet flange bolts using linesman pliers. Then add the self-closing toilet seat…which is super easy. Place the rubber gaskets on the seat’s hinges, then the metal washers (Steve explains which ones to use in the video), and secure the seat to the bowl with the plastic nuts & washers. This new toilet took about 1 hour to install.
How do you install a new toilet on a tile floor?
The 3 stainless-steel bolts are tightened to compress the rubber gasket to secure the flange to the existing pipe. In addition, the compression joint allows up to 3″ of adjustment. This replacement flange is for broken flanges or flanges that sit below the finished tile floor.
Can a tile floor be cut around a toilet?
Cutting flooring around these obstacles is difficult even for the most seasoned flooring installer. With the toilet removed, you can carry the tile all the way up to and around the toilet flange.
In fact, tiling on a second floor is the same as tiling on any wood subfloor, whether it’s the first floor, third floor or second floor. Locate a pipe that goes through the floor. If there is no pipe, drill a hole through the floor, using a power drill.
