Is there a sleep mode on a Cal spa?

There are 3 modes in a Cal Spa. You want it in Standard mode, so press the temp button and the light button within 3 seconds of one another and it will sequence to the next mode, repeat till you are in Standard mode. In Sleep mode nothing works so do not use that. That mode is for cleaning and replacing filters.

How do I Turn Off my Cal spa?

There are 3 modes in a Cal Spa. (St) Standard, (Ec) Economy and (Sl) Sleep You want it in Standard mode, so press the temp button and the light button within 3 seconds of one another and it will sequence to the next mode, repeat till you are in Standard mode. In Ec it will only heat in filter cycle

What are the message codes on Cal spa?

Beginning with the 2014 product line, Cal Spa control panels display different message codes. For a description of these message codes, see the owner’s manual. Use the problem message from the “Problem Messages” Column to diagnose problem

What to do if your spa message does not reset?

Check water level in spa. Refill if necessary. Make sure pumps are been primed and filter cartridges are clean. Press any button to reset or wait 15 minutes and spa will automatically reset. If message spa does not reset, call customer service.

How to troubleshoot a problem with a Cal spa?

Troubleshooting 1 Message on the control panel. A message on the control panel may indicate a problem. 2 Problems starting up. Note: The priming procedure described here applies to Cal Spas built in 2013 and earlier. 3 Power and electrical problems. 4 Heat problems 5 Jet problems 6 Water pressure problems

What are the error codes on the Balboa spa?

Balboa Spa Side Error Codes pd Power supply, unit running on battery ba OH Sensors reading 112-118° F. OHH Overheat. Spa has shut down. One sensor OHS Overheat. Spa has shut down. One sensor